ABB i-bus® EIB Switch/dim actuator, FM Type: 6114 U-500

ABB i-bus ® EIBSwitch/dim actuator, FMType: 6114 U-500 + 6115-2xSwitch Dim Shutter Flex. Alloc. LogicStatus /3Selection in ETS2– ABBPush Button alpha neaPush button, 1-fold for 1SDAThe application program is intendedfor the 1-fold switch sensor applicationmodule in connection with the switch/dim actuator FM.Note: The descriptions for– switch,– dim,– status,– logic,– read-only memory,– bus voltage failure or recoveryhave already been outlined in theapplication description “Switch DimLogic Status Fixed value /1”.The functions of the push button aredescribed in the following section.SwitchIf the parameter “Operation moderocker” is set to “Switching”, the ETS2program displays a furthercommunication object “Push button -Switching”. When the upper contact ofthe push button is pressed, the devicesends an “On” telegram while an “Off”telegram is sent on the EIB when thelower contact is pressed.DimIn the “Dimming” operating mode,ETS2 displays two communicationobjects for the push button fordimming.After a short push button action, thecorresponding 1 bit communicationobject “Push button short - Switching”sends “On” or “Off” telegrams on theEIB.After a long operation, the push buttonsends dimming telegrams to the 4 bitobject “Push button long - Dimming”.When the push button is released, thepush button sends the telegram “Stopdimming”.Pressing the upper contact switcheson or dims brighter. Pressing the lowercontact switches off or dims darker.ShutterIf “Shutter” is selected as the operatingmode, two 1 bit communication objectsare available for the push button.After a long push button action, thecorresponding object “Push buttonlong - Move shutter” sends telegramsfor shutter movement. The object “Pushbutton short - Adjust lamella of shutter”sends “Louvre adjustment / stop”telegrams after a short push buttonaction.Pressing the upper push buttonenables the shutter to be raised i.e. thevalue “0” is sent. After pressing thelower contact, a “1” is sent and theshutter is lowered.Flexible allocationIn the operation mode “Flexibleallocation”, the push button has thetwo 1 bit communication objects“Upper push button - Switching” and“Lower push button - Switching”.With the parameters “Reaction onupper contact” or “Reaction on lowercontact”, it is defined when the pushbutton sends “On” or “Off” telegrams.By default, the push button is toggledafter each operation. With the setting“switch defined”, it can be freelyselected whether a telegram is sentwhen the push button is pressed(rising) or when it is released (falling).With the setting “no reaction”, the pushbutton is switched off.LEDWith the parameter “Operation mode ofLED”, it can be defined whether theLED displays the value of object no. 8“Push button ...” or always lights up inthe same colour as an orientation light.8 - 82 March 2003