Conventional Systems Technical Manual - Alcad

More documents

Recommendations

Info

INSTALLATION ON A STANDARD ELECTRICALBOX. FIXING CONNECTION BRACKET TO THESTANDARD ELECTRICAL BOX.Remember to pass the connections cable through the cablehole of the connections bracket.Fix the connection bracket to the standard electrical box.Make the connections and adjustments as indicated in thediagrams and connection and adjustment instructions of thismanual.DESKTOP INSTALLATION. FIXING THE CONNEC-TION BRACKET TO THE DESKTOP SUPPORTFix the connection bracket to the desktop support with the M3screws provided with the support.Make the connections and adjustments in the connectionbracket using the multiwire SCART connector cable as indicatedin the diagrams and connection and adjustment instructions ofthis manual.Connect the multiwire SCART connector cable to the connectionbase.FIXING TO THE COVER FRAME FOR MONITORSRemember to pass the connections cable through the cablehole of the connections bracket.Fix the connection bracket to the cover frame using thescrews provided with the frame.Make the connections and adjustments as indicated in thediagrams and connection and adjustment instructions of thismanual.A RIBAUPHAUT136
MONITORS FOR HOUSES AND FLATSIDENTIFYING THE TYPE OF MONITORThe steps to follow in order to install or to dismount the monitordepend on which type of monitor it is. For monitors with afixing tongue of type (1) in their base, follow the steps shownunder “Monitors Type 1”. For monitors with a fixing tongue oftype (2) in their base, follow the steps shown under “MonitorsType 2”.12Monitor type 1 Monitor type 2FITTING THE MONITOR TO THE CONNECTIONBRACKETConnect the connector of the monitor to the connectionbracket.“Monitors type 1”Clip the two top fitting hooks of the bracket into the guideson the base of the monitor housing (1). To do so, incline themonitor as shown in the picture below. The monitor will then beheld by the connection bracket.Monitor type 1 Monitor type 2120mm20mm“Monitors type 2”Starting from the position shown in the illustration (i.e. withthe upper part of the monitor approximately 20mm above theconnections bracket), move the monitor closer to the connectionsbracket in such a way that the upper fixing tongues of thebracket clip into the guides in the base of the monitor (1).11“Monitors type 1”Push the monitor downwards (2). While still pushing (2),apply frontal pressure to the lower part of the monitor (3) untilit is in a position parallel to the wall. Then move the monitorslightly upwards to anchor it to the connections support (4).Monitor type 1 Monitor type 22“Monitors type 2”While holding the position indicated in the former step, pushthe monitor downwards.43137
Page 1:
ACCESS CONTROL SYSTEMSCONVENTIONAL
Page 5 and 6:
LASTFLOOR5GROUNDFLOORTELEPHONE INTH
Page 7:
DIRECT CONNECTIONS BETWEEN THE PANE
Page 10 and 11:
1 2 34 5 67 8 9C 0POSSIBILITY OF IN
Page 12:
COMMUNICATION SYSTEM WITH 6+N+COAXI
Page 16 and 17:
230V~ ±10%50-60HzDC OUT : 15V0.2 A
Page 18 and 19:
OFFONOFFONSYSTEM ON STANDBY. NO CAL
Page 20 and 21:
OFFONOFFONOFFONOFFONOFFONOFFONTRANS
Page 22 and 23:
1 2 347 8 9C 01 2 347 8 9C 01 2 347
Page 24 and 25:
1 2 347 8 9C 01 2 347 8 9C 01 2 34
Page 27 and 28:
AUTO SWITCH-ON FUNCTION (monitors)T
Page 29 and 30:
TV DOOR ENTRY SYSTEM INSTALLATIONST
Page 31 and 32:
cod.9730015T1+ T1 T1 T1+ T1+ T1 T1+
Page 33 and 34:
ARRIBAUPHAUT230V~ ±10%DC OUT50-60H
Page 35 and 36:
ELECTRONIC CALL SYSTEM84 mmCod. 960
Page 37:
84 mmCod. 9600012TES-002ELECTRONIC
Page 40 and 41:
84 mmCod. 9600011TUN-002UNIVERSAL T
Page 42:
ACCESSORIES FOR TELEPHONESDESKTOP S
Page 45 and 46:
CC1CC1Monitor connectorTERMINALS IN
Page 47 and 48:
ARRIBAUPHAUTCod. 9730034MAE-900GENE
Page 49 and 50:
12 VV+15 Vcod.9730016T1+ T1 T1+ T1
Page 51 and 52:
A brief description of each entranc
Page 53 and 54:
SINGLE BLANK MODULES78.5 mm128 mm12
Page 55 and 56:
126.5 mm128 mm12 mmCod. 9670122 MDN
Page 57 and 58:
UPPER MODULES WITH CARD-HOLDER AND
Page 59 and 60:
AUDIO UNITS IN ENTRANCE PANELS WITH
Page 61 and 62:
21Cod. 9610030GRF-204ELECTRONIC AUD
Page 63 and 64:
Description of terminals and typica
Page 65 and 66:
Cod. 9640009TCB-021GENERIC COLOUR V
Page 67 and 68:
Cod. 9640008TCB-050GENERIC COLOUR V
Page 69 and 70:
ENTRANCE PANEL LOWER MODULES212121T
Page 71 and 72:
LOWER ENTRANCE PANEL MODULES WITH C
Page 73 and 74:
SINGLE MODULES WITH CARD-HOLDER78.5
Page 75 and 76:
OFFONTELEPHONES FOR CONCIERGE SYSTE
Page 77 and 78:
ARRIBAUPHAUTARRIBAUPHAUTARRIBAUPHAU
Page 79 and 80:
COVER FRAMES FOR ENTRANCE PANELFram
Page 81 and 82:
25 mmCod. 9730033 ESC-010LONG SHIEL
Page 83 and 84:
BUZZING CALL50 mmCód. 9730020AAL-2
Page 85 and 86: Ctrl15A / 250V~40 mmS2 S52 588 mm6A
Page 87 and 88: Made in SpainCALL ADAPTER ACCESSORI
Page 89 and 90: 70 mm111 mm42 mm230V~ ±10%50-60HzD
Page 91 and 92: 90 mm230 V V106 mmCod. 9620002ALA-0
Page 93: Description of terminals and techni
Page 96 and 97: ARRIBAUPHAUTARRIBAUPHAUTARRIBAUPHAU
Page 104 and 105: 4MECHANICAL ASSEMBLYACCESSORIES FOR
Page 106 and 107: SURFACE WALL-MOUNTED BOXBREAKING TH
Page 108 and 109: RAIN-SHIELDSRAIN-SHIELDS FOR FLUSH-
Page 110 and 111: ENTRANCE PANELS WITH PUSHBUTTONSCON
Page 112 and 113: POSITIONING THE ENTRANCE PANELSPOSI
Page 114 and 115: If a rain-shield is being added, fi
Page 116 and 117: Once the electrical connections and
Page 118 and 119: CONCIERGE SYSTEMS: TELEPHONES FOR C
Page 120 and 121: Separate the upper and lower decora
Page 122 and 123: POSITIONING THE TELEPHONE FOR CONCI
Page 124 and 125: ASSEMBLING THE COVER OF THE TELEPHO
Page 126 and 127: PUSHBUTTONSASSEMBLING THE PUSHBUTTO
Page 128 and 129: cod.9730015T1+ T1 T1 T1+ T1+ T1 T1+
Page 130 and 131: TELEPHONES FOR HOUSES AND FLATSDISA
Page 132 and 133: Close the telephone and fix the cov
Page 134 and 135: COVER FRAMES FOR MONITORSPLACE AND
Page 138 and 139: Put the receiver in place and conne
Page 140 and 141: CtrlCtrlCtrlSWITCH-SELECTOR ACCESSO
Page 142 and 143: MODULATORS FOR TV DOOR ENTRY INSTAL
Page 144 and 145: CONNECTIONS AND ASSEMBLY OF TERMINA
Page 146 and 147: ADJUSTMENTSelecting the call toneTh
Page 148 and 149: Electronic door entry with concierg
Page 150 and 151: Description of connections:Electron
Page 152 and 153: Adjusting the volume controlsThe au
Page 154 and 155: Replacement installationsPower supp
Page 156 and 157: VIDEO UNITS IN ENTRANCE PANELS WITH
Page 158 and 159: ADJUSTMENTControl of the angle of v
Page 160 and 161: ADJUSTMENTAdjusting the volume cont
Page 162 and 163: TWISTED PAIRTAP-OFF DIV-034CONNECTI
Page 164 and 165: TELEPHONES FOR HOUSES AND FLATSTELE
Page 166 and 167: Electronic door entry installations
Page 168 and 169: TELEPHONE FOR INTERNAL COMMUNICATIO
Page 170 and 171: Replacement installationsNext telep
Page 172 and 173: ADJUSTMENTSReplacement installation
Page 174 and 175: 5A / 250V~ACCESSORIES FOR MONITORSD
Page 176 and 177: Description of terminals:CC1CC1Moni
Page 178 and 179: Distribution of the video signal vi
Page 180 and 181: Description of connections:CC1Next
Page 182 and 183: DIV-034cod.9730015T1+ T1 T1 T1+ T1+
Page 184 and 185: ELECTRONIC ACCESSORIESCALL EXTENSIO
Page 186 and 187:
COMPATIBILITY TABLEMODELALCAD AAL-2
Page 188 and 189:
ACTIVATING BY EXTERNAL CONTROL SIGN
Page 190 and 191:
Description of connections:Power su
Page 192 and 193:
ADJUSTMENTSelecting the output chan
Page 194 and 195:
POWER SUPPLY UNITSPOWER SUPPLY ALA-
Page 196 and 197:
6DIAGRAMSGENERAL POINTS CONCERNING
Page 198 and 199:
STANDARD INSTALLATION IN BUILDINGCO
Page 200 and 201:
INSTALLATION IN BUILDING WITH SEVER
Page 202 and 203:
VHOUSING ESTATE WITH 3 BUILDINGS. 1
Page 204 and 205:
DOOR ENTRY INSTALLATIONS WITH CONCI
Page 206 and 207:
Page 208 and 209:
DOOR ENTRY INSTALLATIONS. BUZZING C
Page 210 and 211:
Page 212 and 213:
HOUSING ESTATE WITH 3 BUILDINGS. 1
Page 214 and 215:
Made in SpainMade in SpainBUILDING
Page 216 and 217:
DOOR ENTRY INSTALLATIONS WITH CONFI
Page 218 and 219:
Page 220 and 221:
HOUSING ESTATE WITH 3 BUILDINGS. 1
Page 222 and 223:
VVVHOUSING ESTATE WITH 3 BUILDINGS.
Page 224 and 225:
1 2 34 5 67 8 9C 01 2 34 5 67 8 9C
Page 226 and 227:
1 2 34 5 67 8 9C 02 34 5 67 8 9C 0S
Page 228 and 229:
1 2 34 5 67 8 9C 02 34 5 67 8 9C 0E
Page 230 and 231:
VIDEO DOOR ENTRY INSTALLATIONS. ELE
Page 232 and 233:
STANDARD INSTALLATION IN BUILDING:
Page 234 and 235:
Page 236 and 237:
INSTALLATION IN BUILDING WITH 2 POI
Page 238 and 239:
HOUSING ESTATE WITH 3 BUILDINGS WIT
Page 240 and 241:
19J1HOUSING ESTATE WITH 3 BUILDINGS
Page 242 and 243:
cod. 9610001STANDARD INSTALLATION I
Page 244 and 245:
STANDARD INSTALLATION IN BUILDING:
Page 246 and 247:
DIV-034cod.9730015T1+ T1 T1 T1+ T1+
Page 248 and 249:
DIV-034cod.9730015T1+ T1 T1 T1+ T1+
Page 250 and 251:
DIV-034cod.9730015T1+ T1 T1 T1+ T1+
Page 252 and 253:
HOUSING ESTATE WITH 3 BUILDINGS WIT
Page 254 and 255:
Page 256 and 257:
1 2 34 5 67 8 9C 01 2 34 5 67 8 9C
Page 258 and 259:
CONVENTIONAL SYSTEM 6+N+TWISTED PAI
Page 260 and 261:
WIRED DIAGRAMINSTALLATION WITH TAP-
Page 262 and 263:
WIRED DIAGRAMINSTALLATION WITH TAP-
Page 264 and 265:
R1WIRED DIAGRAMA J1A J1A J1R1SCM-01
Page 266 and 267:
R1WIRED DIAGRAMA J1A J1A J1R1SCM-02
Page 268 and 269:
Page 270 and 271:
1 2 34 5 67 8 9C 0DOOR ENTRY INSTAL
Page 272 and 273:
CONVENTIONAL SYSTEM 6+N+TWISTED PAI
Page 274 and 275:
INSTALLATIONS WITH AUDIO UNIT GRF-2
Page 276 and 277:
DOOR ENTRY INSTALLATIONS WITH CONFI
Page 278 and 279:
OPENING OF A SECOND DOOR FROM THE T
Page 280 and 281:
ACTIVATING A 12VAC ELECTRIC LOCKUse
Page 282 and 283:
DOOR ENTRY INSTALLATIONSWIRED DIAGR
Page 284 and 285:
ACTIVATING A LIGHT, BELL OR SIREN W
Page 286 and 287:
230V~ ±10%50-60HzDC OUT : 15V0.2 A
Page 288 and 289:
TV DOOR ENTRY INSTALLATION IN A STA
Page 290 and 291:
Page 292 and 293:
You cannot hear one of the telephon
Page 294 and 295:
ELECTRONIC DOOR ENTRY INSTALLATIONS
Page 296 and 297:
ELECTRONIC DOOR ENTRY INSTALLATIONS
Page 298 and 299:
INTERNAL COMMUNICATION INSTALLATION
Page 300 and 301:
ELECTRONIC VIDEO DOOR ENTRY INSTALL
Page 302 and 303:
Page 304 and 305:
ELECTRONIC VIDEO DOOR ENTRY INSTALL
Page 306 and 307:
Page 308 and 309:
TV DOOR ENTRY INSTALLATIONSSTANDARD
show all

Conventional Systems Technical Manual - Alcad

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?