Conventional Systems Technical Manual - Alcad

CONCIERGE SYSTEMIn electronic door entry installations with concierge system, as well as selecting the appropriate upper modulefor the entrance panel of the installation (see the table on page 50), you will need a special panel and aspecial telephone for the concierge unit. These will enable you, wherever you decide to install them, to receiveand manage all calls made to the dwellings.Concierge panelConcierge telephoneCONCIERGE UNIT PANEL12The concierge unit panel consists of two modules. These modules constitute the upper part (1) and lower part(2) of the concierge unit to be installed. Any configuration of the concierge unit panel can be achieved by thedifferent combinations available. Several concierge unit panels can be connected side by side to obtain thedesired number of pushbuttons.The choice of the upper and lower modules, as well as the number of entrance panels required , will determinethe final size of the panel and, consequently, the dimensions and the number of flush-mounted or surfacewall-mounted boxes to be used. See chapter 3 “Entrance panels: dimensions and accessories”.CONCIERGE UNIT PANEL UPPER MODULESThese modules, manufactured with an aluminium profile, incorporate the audio unit and the card-holder, or neither of these.Two TORX tamper-proof screws are provided with the upper modules. These replace the standard screws of the entrance panelcover frame and prevent unauthorised persons from tampering with the panel.The following pages describe each of the upper modules of the concierge unit panel.CONCIERGE UNIT PANEL SINGLE UPPER MODULESSINGLE MODULES WITH AUDIO UNIT78.5 mm128 mm12 mmCod. 9670117MAN-460ENTRANCE PANEL MODULE WITH GRF-206CONCIERGE AUDIO UNITModule which houses the electronic audio unit, for conciergeinstallations, model GRF-206 (1). Fitted with rubber strips forwater-tightness and with rings (2) for hanging in the flush-mountedbox.2172