Conventional Systems Technical Manual - Alcad

ARRIBAUPHAUTDescription of terminals and typical voltages depending on the condition of the equipment:Note: The voltages shown are reference values provided for the testing of the equipment and are intended for use exclusivelywith ALCAD audio units. Do not use the terminals of the equipment to supply power to additional devices without previously consultingthe manufacturer.CC11 2 3 4 21 14 13CC21 , 23 , 24 , 221 , 214 , 213 , 2CC1CC2Telephones lock releaseTelephones microphoneTelephones loudspeakerEntrance panel lock releaseElectronic callConcierge (control signal)Concierge audio unit key connector(pre-wired)Concierge audio unit connectorTERMINALS1 , 23 , 24 , 221 , 2CONCIERGE DEACTIVATEDAT REST5 V8 V0 VWORKING0 V5.6 - 6.6 V4 Vpp0 VppAT REST8 VCONCIERGE ACTIVATEDWORKING5 V 0 V5.6 - 6.6 V4 Vpp0 V 0 Vpp5 V 0 V5 V 0 V14 , 20 V7.0 Vpp9 V13, 20 V9 VACCESSORIES FOR ENTRANCE PANELS.ACCESSORIES FOR CONCIERGE SYSTEMSFLUSH-MOUNTED BOXESB mm (depending on the model)114 mm45 mmFlush-mounted boxes are used to fix the entrance panel or the concierge unit in the desired place insuch a way the the panel or the concierge unit is flush with the wall.Flush-mounted boxes have protection plugs (1); support axles to tilt (2); and diverse points throughwhich the cable hoses can be passed (3). They have lateral walls (4), which facilitates the connectionof several flush-mounted boxes (to install panels in parallel). In this case, CEM-001 separators must beused.Selecting the flush-mounted box:The choice of flush-mounted box will be determined by thedimensions of the panel to be installed.In the Chapter 3 “Entrance panels: dimensions andaccessories”, you will find a table showing which model offlush-mounted box you should use with which entrance panelor concierge system.1243SEPARATOR FOR FLUSH-MOUNTED BOX76Cod. 9740004 CEM-001SET OF SEPARATORS FOR FLUSH-MOUNTED BOXESElements which permit the assembly of several flush-mounted boxes. Usedwhen several panels are installed in parallel, they ensure the necessary separationbetween boxes in such a way that the panels remain correctly aligned. Oneset of separators is required for each pair of flush-mounted boxes.Note: Bear in mind that for each set of separators used, the width of the wallcavity must be increased by 15mm.