Conventional Systems Technical Manual - Alcad

1 2 34 5 67 8 9C 02 34 5 67 8 9C 0ELECTRONIC DOOR ENTRY INSTALLATION IN BUILDING WITH SEVERAL POINTSOF ENTRY WITH INTERNAL COMMUNICATION BETWEEN THE TELEPHONES INONE OF THE DWELLINGSCONVENTIONAL SYSTEMStandard wiring diagram for electronic door entry system with electronic call in buildings with several points of entry where thepossibility of internal communication is required between the telephones of one dwelling. Characteristics of the internal communication:electronic call and and internal communication channel, with complete confidentiality.RemarksDetermining the main entrance panelOne of the entrance panels must be configured as the main panel (audio unit with J1 jumper installed). The panels of the otherpoints of entry must be configured as secondary panels (remove the J1 jumper from audio units).Assigning a extension number to each telephoneA different extension number is assigned to each telephone with internal communication. (See in chapter 5 the adjustment instructionsof telephone for internal communication).SINGLE-WIRED DIAGRAM5SECTION TABLEAWGUp to 50 metres1 mm 21.1 mm 17Up to 25 metres0.5 mm 20.8 mm 20TEL-001LAST FLOORUp to 100 metres1 mm 2 1.1 mm 172 0.25 mm 0.6 mm 225512TIN-001512TIN-001(3)12342 0.25 mm 0.6 mm 222 0.5 mm 0.8 mm 202 0.75 mm 1.0 mm 182 1 mm 1.1 mm 17(1) Use separate cable hose(2) Max. 12 Vac, 800 mA(3) Section according to the numberof telephones in the dwellingTEL-001GROUND FLOOR2GCI-001230 V I2 I1ALA-040 (230 V )4+NALA-040 (230 V )230 V V2POINT OFENTRY 1230 V V2POINT OFENTRY 2230 VNEXTPOINT OF ENTRY(1)6+N (1)6+N22ABR-001(2)MAN-430+MPD-004+CMO-004ABR-001(2)MAN-430+MPD-004+CMO-004228