Conventional Systems Technical Manual - Alcad

MONITORS FOR HOUSES AND FLATSIDENTIFYING THE TYPE OF MONITORThe steps to follow in order to install or to dismount the monitordepend on which type of monitor it is. For monitors with afixing tongue of type (1) in their base, follow the steps shownunder “Monitors Type 1”. For monitors with a fixing tongue oftype (2) in their base, follow the steps shown under “MonitorsType 2”.12Monitor type 1 Monitor type 2FITTING THE MONITOR TO THE CONNECTIONBRACKETConnect the connector of the monitor to the connectionbracket.“Monitors type 1”Clip the two top fitting hooks of the bracket into the guideson the base of the monitor housing (1). To do so, incline themonitor as shown in the picture below. The monitor will then beheld by the connection bracket.Monitor type 1 Monitor type 2120mm20mm“Monitors type 2”Starting from the position shown in the illustration (i.e. withthe upper part of the monitor approximately 20mm above theconnections bracket), move the monitor closer to the connectionsbracket in such a way that the upper fixing tongues of thebracket clip into the guides in the base of the monitor (1).11“Monitors type 1”Push the monitor downwards (2). While still pushing (2),apply frontal pressure to the lower part of the monitor (3) untilit is in a position parallel to the wall. Then move the monitorslightly upwards to anchor it to the connections support (4).Monitor type 1 Monitor type 22“Monitors type 2”While holding the position indicated in the former step, pushthe monitor downwards.43137