Conventional Systems Technical Manual - Alcad

ARRIBAHAUTARRIBAHAUTARRIBAHAUTARRIBAHAUTARRIBAHAUT3ENTRANCE PANELS:DIMENSIONS AND ACCESSORIESENTRANCE PANELS WITH PUSHBUTTONSWith the right combination of upper and lower entrance panel modules, you can perform any kind of installation: of one or of severalpanels, and for one or for several points of entry.Depending on the model of lower module with pushbuttons and on the type of upper module (simple, double or triple) chosen, the heightof the entrance panel will vary, although the width will remain constant.The possible combinations of the different upper and lower panel modules are shown on the following pages. The dimensions of themounted panel are shown, as are those of the required flush-mounted or surface wall-mounted box in each case.Bear in mind that, when combining different entrance panels (i.e. panels in parallel), you will need to have as many flush-mounted boxesas panels, as well as the appropriate number of flush-mounted box separators. These separators will increase the stated width of eachflush-mounted box by 15mm. (For more information, see the technical information of the set of separators on page 76). When using surfacewall-mounted boxes, use a single surface wall-mounted box for each entrance panel. If required, use a set of separators for everytwo surface wall-mounted boxes. (See the technical information on the set of separators for surface wall-mounted boxes on page 77).Compact modulewith video unitFlush-mounted boxSurface wall-mounted boxCMO-002CSU-211Entrance panel lower module Entrance panel single upper module Flush-mounted box Surface wall-mounted boxMPD-002CMO-002CSU-211Entrance panel lower module Entrance panel double upper module Flush-mounted box Surface wall-mounted boxMPD-002CMO-004CSU-212Entrance panel lower module Entrance panel single upper module Flush-mounted box Surface wall-mounted boxMPD-002MPD-002CMO-002 x 2+CEM-001CSU-211 x 2+CSU-00095