M300 Owner's Manual-English - Lexicon

300 V 3.0 Owner's ManualSplit SetupEffect DescriptionsLexiconFor your reference, all of the presets effects available in the split mode are listedand described below, in numerical order.EP # Name Algorithm Description601 *Dual Delays Dual Delays Baseline effect with the Soft knob patched to the last two delay linesin the signal path. Advancing the Soft knob parameter will cause thetwo post-delays to move in sync out to more than 2200ms.602 Space Delays Dual Delays This preset incorporates a bit of left-right diffused delay along withsome small delay offset between left and right delay outputs. If theeffect is too strong you could try turning back the feedback levels forDelays 3 and 4.603 *Pingo Pongo Dual Delays Ping - Pong delays bouncing back and forth. The Soft knobparameter controls the timing of the bounce.604 *3Voice Dlys Dual Delays Two taps (Delay 3 and 4 ) are set with delay ratios of 1:2 —meaning when one is 200ms the other is 400ms, or when one is 359the other is 718ms. This relationship is patched to the Soft knob.605 OverTheTop1 Dual Delays This preset should be used pretty much through the box, i.e. send ita pre-fader signal then mix only the returns. Flange Delay ispatched to the LFO. When properly modulated, the flange delayglides between 9.5 and 18.7ms. The base delays are set to 10mswith a positive feedback gain. Over the top cancellation occurs asthe glide delay passes over the 10ms base delay. Remember, theLFO is part of the Setup, so if you load the effect into a Setup wherethere is no LFO activity, the preset will sound “hollow” and resonant!606 OverTheTop2 Dual Delays Similar to OverTheTop1 except the flange delay glides between0.08 and 10.7ms. Flange Delay is patched to the LFO. The basedelays are set to 10ms with a negative amplifier gain. Over the topcancellation occurs as the glide delay passes over the 10ms basedelay. The channel outputs are reversed such that the left input willpass through to the right output and vice-versa. Remember, theLFO is part of the Setup, so if you load the effect into a Setup wherethere is no LFO activity, the preset will sound “hollow” and resonant!607 LFO:FazeDlys Dual Delays Faze Dlys also makes use of the LFO again to the Flange GlideDelay (FGLD). The base delays are set in different time domains;one side at 1.9ms with a feedforward gain and the other at 5.6 witha negative feed gain. As the glide passes over each base delay thephase of each gain is changed and in between the output is amixture of each. A great effect on a ripping guitar solo.608 Env:Phazer Dual Delays This preset makes use of a patch between the envelope detector inthe meters and the Flange Glide Delay. As signal becomesstronger the glide delay drops in time domain eventually crossingthe 5.2 ms base delays. As audio signal strength lessens the glidereturns to its preset value of 10ms. Very good on vocals. To makethis effect work properly be sure to drive the 300 to within 12dB offull scale (dBfs).5-20