M300 Owner's Manual-English - Lexicon

300 V 3.0 Owner's ManualLexiconIf the system is properly locked, the Inp field should now be displaying either“AES” or “SPDIF”. If the system is not properly locked to the incoming word clock,the following error message will be displayed:BAD/NO DIGITAL INPUTCheck Din connector!Go back and check all your cables.Once you’ve configured the Analog or Digital audio type, return to the SetupSelect mode by pressing SETUP SELECT.Single SetupsSINGLE Setups (101-150) configure both DSP engines with microcode whichenables them to function as a unified engine. Both analog and digital inputs canbe utilized simultaneously. Each type of input (A or D) has a source Level andBalance control. The Level control varies the input level to the DSP engine foreach type of input; Analog or Digital. The Balance controls determine what ratioDryAnalogLRDigitalAnalogLevelAnalogBalanceΣΣEFFECTEDITOverallMixAnalog andDigital OutLRLRDigitalLevelDigitalBalanceDryof Left/Right balance feeds the DSP engine.(Analog and digital input levels and balances are located on Page 2 of theSETUP EDIT mode. Press SETUP EDIT, then press PAGE DOWN once.)ExampleAll SINGLE Setups have Balance set to 50%. This means an equal proportionof Left and Right input signal is passed into the (Single) Effect.1. Press the ABAL (Analog Balance).2. Turn the Soft knob counterclockwise to let more of the Left input pass through.3. Turn the knob clockwise to allow more of the Right channel to pass through.4. Return the parameter to 50%, allowing proper stereo to pass to the DSPeffect.Before the signal passes into the loaded effect, a post input level and postbalance is picked off and bypasses the effect. Lexicon calls this the Dry signalpath. The Dry signal and the Wet DSP effect signal are summed andproportionally mixed by the control labeled OMIX (Overall Mix). This control isfound on the next Page. (Press PAGE DOWN once.) The resulting mix is passedout both analog and digital.3-4