M300 Owner's Manual-English - Lexicon

300 V 3.0 Owner's ManualEffect Edit ModeLexiconThe 300 is shipped with 100 effect presets. Sooner or later you will want to alterthe sounds of these effects to more perfectly fit your requirements. To do this,goto Run mode and load a preset setup that uses the effect you want to edit — orselect and load the effect you want to edit from Page One in Setup Edit mode.Once the setup is loaded, pressing EFFECT EDIT will put you in Effect Editmode with the display showing one page of the parameters available for thealgorithm driving that effect.Parameter SelectionThe algorithms and their parameters are described in detail in Chapter 4. We'vechosen the first page of Random Hall parameters to show here as an example:RTIM SIZE ROLL PDLYRLVL TDCY BASS XOVRThe buttons directly above and below each display entry will select thatparameter. Once selected, parameters can be adjusted over their entire rangewith the Soft knob. The parameter and its current value will appear on the displayas long as the Sof tknob is being adjusted. In the example above, "RTIM" hasbeen selected — turning the Soft knob will alter the parameter value, and causethe display to show:SETUPSELECTMACHCONTROLSETUPMid Reverb TimeXX.XX secondsSTOREVALUEEDITEFFECTEDITMODPressing the front panel VALUE key will display all of the current parametervalues for the selected page. in this example, pressing VALUE will cause thefollowing display to appear:EDITXX.Xs 37.1M 2.9k 22mFULL 3.6k 1.2X 0.5k3-18