M300 Owner's Manual-English - Lexicon

300 V 3.0 Owner's ManualLexiconThe LFO (Low Frequency Oscillator) is a control generator which is designed tomodulate Effect or Setup parameters in the 300 when parameters are patchedto it. The LFO has a shape and a rate (speed) function, available on Page Four.The shape can be SINEusoidal, TRIANGLE, SQUARE, or RANDOM. Rate isadjustable from Off to 9.0Hz.The action of the meters is determined on Page Five. The choices are:ANA IN (Analog In) for either Left or Right channelDIG IN (Digital In) for either Left or Right channelFX-OUT for either Left or Right channel ( commonly referred to as the WET BUS)Note: If you choose Left Meter or Right Meter as Patch sources when makingMOD Edits, you are essentially linking the ballistics of the meter to the assigneddestination.Pages Six and Seven allow you to make as many as two MOD patches in theSetup domain. As an example, try patching the LFO to a Balance parameter asfollows:1. The display should read:Patch #1S DEST VALUESOURCE THRS SCALE2. If DEST is not underscored, press the button directly beneath it to select it.Once it is underscored, turn the softknob to select ANALOG BALANCE.The display will revert to its state in Step 1 after approximately 20 seconds.To return immediately to this display, press SETUP EDIT.3. Select SOURCE by pressing the button directly beneath it. Turn thesoftknob fully clockwise until the display reads LFO_1.4. Before doing anything else, press PAGE UP twice to the LFO control page.Select RATE and adjust it to .07Hz. (Leave Shape at SINE.) The displayshould start to flicker.5. Press PAGE UP twice to the Level and Balance Page. Press the VALUEkey. The value of ABAL (balance) should be modulating from left to right.Although very simplified, this is the basic model for making MOD patches in the300.To disable the patch, press SETUP SELECT and reselect the Setup, therebyrestoring the original settings. Alternatively, you can return to the LFO Ratepage, and set the rate to OFF.On Page Eight you can name your Setup prior to storing it into a register. Thearrow (cursor) keys allow you to select a letter to change; the softknob actuallychanges the character. The maximum length of a name is 12 characters.3-14