M300 Owner's Manual-English - Lexicon

More documents

Recommendations

Info

300 V 3.0 Owner's ManualLexiconFBK1 , FBK2DLY3 , DLY4LVL3,LVL4FBK1 and FBK2 determine the amount of recirculation passed back through tothe left and right inputs.DLY3 (0ms-1000ms) and DLY4 (0ms-1000ms) are also picked off after thediffusor. The level of each is controlled by LVL3 and LVL4, respectively.LVL3 and LVL4 determine the loudness of DLY3 and DLY4.DLY5 , DLY6FBK5, FBK6DLY5 (0ms-2800ms) and DLY6 (0ms-2800ms) allow you to build non-diffusedrecirculating echoes independent of the reverberator. Each has a feedbackcontrol (FBK5 and FBK6).FBK5 and FBK6 provide feedback control for DLY5 and DLY6.LVL5,LVL6LVL5 and LVL6 determine the loudness of DLY5 and DLY6. Remember, theseare undiffused pre-echoes.4-14
The Algorithms and their ParametersStereo Pitch ShiftStereo Pitch Shift is a stereo or two-channel mono pitch shifter with severaluseful effects, including predelay, feedback, and glide. These are independentlyadjustable for each channel. The pitch shifter in the 300 includes a pitchdetection feature which automatically adjusts the period of the splices to matchthe pitch of incoming signals. This feature greatly reduces the artifacts associatedwith pitch shift. In stereo mode both channels are linked, and the sum of thetwo channels (L & R) is used in the pitch detector. In mono mode each channelsplices independently. In either case it takes about 40 ms for the pitch detectorto obtain an optimal pitch value. Setting the LDLY and RDLY controls to thisvalue will give the smoothest pitch shift. Shorter values can be used for specialeffects, or when extra delay cannot be tolerated.General DescriptionThere are three interacting controls for pitch described below: Glide, PitchInterval, and Fine Pitch. Adjusting any pitch control activates a long display thatshows the pitch percentage, the musical interval, and any fine adjustment incents. Always use this long display when matching Glide to Pitch Interval andFine Pitch.Stereo Pitch Shift Mode, Pitch and EffectsMODE GLDL - GLDRMono/Stereo -2 Oct to +M7+48¢ - -2 Oct to +M7+48¢PCHL FINL PCHR FINR-2 Oct to +M7+48¢ + 100 cents -2 Oct to +M7+48¢ + 100 centsStereo Pitch Shift Delay and FeedbackLDLY LFBK RDLY RFBK0-510ms 0-98%, Max 0-510ms 0-98%, MaxBNPS SYNC - -On/Off On/Off - -Effect Naming PageStereo PitchShift ParametersFeedbackBandpass Sync ModeMono orStereoΣΣShifterPITCH FINE GLIDEShifterPITCH FINE GLIDEL DelayR DelayFeedback4-15
Page 2 and 3:
Unpacking and InspectionAfter unpac
Page 4 and 5:
Contents, cont'd. 4. The Algorithms
Page 6 and 7:
Congratulations on your purchase of
Page 8 and 9:
Installing the 300Installing the300
Page 10 and 11:
Installing the 300The Rear PanelTim
Page 12 and 13:
Installing the 300CablesFor best pe
Page 14 and 15:
Installing the 300ConfigurationsCon
Page 16 and 17:
PUSHPUSHPUSHPUSHPUSHPUSHPUSHPUSHIns
Page 18 and 19: PUSHPUSHPUSHPUSHInstalling the 300A
Page 20 and 21: 300 V 3.0 Owner's ManualLexiconTerm
Page 22 and 23: 300 V 3.0 Owner's ManualLexiconThe
Page 24 and 25: 300 V 3.0 Owner's ManualLexiconOver
Page 26 and 27: 300 V 3.0 Owner's ManualLexiconSETU
Page 28 and 29: System Operation3System Operation3-
Page 30 and 31: System OperationIf you wish to chan
Page 32 and 33: System OperationNOTE: Most studio a
Page 34 and 35: System OperationWhen working in a f
Page 36 and 37: System OperationSetup Select mode a
Page 38 and 39: System OperationTo enter Setup Sele
Page 40 and 41: System OperationSetup Edit mode is
Page 42 and 43: System OperationWhen you have made
Page 44 and 45: System OperationPage FiveNaming the
Page 46 and 47: System OperationHere again, turning
Page 48 and 49: System OperationSoft knob patches a
Page 50 and 51: System OperationThe MIDI Control pa
Page 52 and 53: System OperationPage FiveSCMS ModeS
Page 54 and 55: System OperationSrc : SET Large Hal
Page 56 and 57: 300 V 3.0 Owner's ManualSingle Setu
Page 58 and 59: 300 V 3.0 Owner's ManualRandom Hall
Page 60 and 61: 300 V 3.0 Owner's ManualLexiconRand
Page 62 and 63: 300 V 3.0 Owner's ManualLexiconRand
Page 64 and 65: 300 V 3.0 Owner's ManualRLVL (Rever
Page 66 and 67: 300 V 3.0 Owner's ManualLexiconRich
Page 70 and 71: 300 V 3.0 Owner's ManualLexiconSter
Page 78 and 79: 300 V 3.0 Owner's ManualDual Delays
Page 80 and 81: 300 V 3.0 Owner's ManualLexiconSpli
Page 82 and 83: 300 V 3.0 Owner's ManualSPRD (Sprea
Page 84 and 85: 300 V 3.0 Owner's ManualLexiconDLYD
Page 86 and 87: 300 V 3.0 Owner's ManualCompressorP
Page 88 and 89: 300 V 3.0 Owner's ManualLexiconSmal
Page 90 and 91: 300 V 3.0 Owner's ManualLexiconin p
Page 92 and 93: 300 V 3.0 Owner's ManualThe Setup P
Page 94 and 95: 300 V 3.0 Owner's ManualLexiconSing
Page 96 and 97: 300 V 3.0 Owner's ManualSplit Setup
Page 98 and 99: 300 V 3.0 Owner's ManualLexiconP208
Page 110 and 111: 300 V 3.0 Owner's ManualSplit Setup
Page 112 and 113: 300 V 3.0 Owner's ManualLexiconEP #
Page 114 and 115: 300 V 3.0 Owner's ManualLexiconEP #
Page 116 and 117: 300 V 3.0 Owner's ManualLexiconEffe
Page 118 and 119:
300 V 3.0 Owner's ManualEffect Pres
Page 120 and 121:
300 V 3.0 Owner's ManualLexiconEffe
Page 122 and 123:
Page 124 and 125:
Page 126 and 127:
Page 128 and 129:
300 V3.0 Owner's ManualLexiconUsing
Page 130 and 131:
300 V3.0 Owner's ManualSnapping eve
Page 132 and 133:
300 V3.0 Owner's ManualProgrammingP
Page 134 and 135:
300 V3.0 Owner's ManualThings to Co
Page 136 and 137:
300 Event List300 V3.0 Owner's Manu
Page 138 and 139:
300 V 3.0 Owner's ManualLexiconThe
Page 140 and 141:
300 V 3.0 Owner's ManualLexiconDyna
Page 142 and 143:
300 V 3.0 Owner's ManualReal-time M
Page 144 and 145:
300 V 3.0 Owner's ManualMIDI Dumps
Page 146 and 147:
300 V 3.0 Owner's ManualTroubleshoo
Page 148 and 149:
MIDI Implementation Data9MIDI Imple
Page 150 and 151:
Specifications10300 Specifications1
Page 152 and 153:
SpecificationsAnalog Input to Analo
show all

M300 Owner's Manual-English - Lexicon

Create successful ePaper yourself

Delete template?

Save as template?