You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
300 V 3.0 <strong>Owner's</strong> <strong>Manual</strong><strong>Lexicon</strong>Page ThreeMachine ConfigurationMach Conf:I : ANALOGDual-MonoO : ANA+DIGThe upper line of this page describes the current machine configuration (Single,Dual Mono or Cascade). The information that appears here is determined by thetype of Setup currently running.Either of the two left buttons on the botton allow selection of Input: ANALOG andDIGITAL are available as choices with all types of setups. A>L D>R (Analog/Left, Digital/Right), or D>L A>R (Digital/Left, Analog/Right) is available forselection in Dual Mono setups..The two right buttons on the bottom row allow selection of Output: ANA+DIG isavailable in all setup types. A(D Pre), or A(D Pst) and D(A Pre), or D(A Pst) areavailable in Dual Mono setups. Cascade setups display choice between A(DPre, Mid or Pst) and D(A Pre, Mid or Pst) for patch point selection.Page FourDigital Interface andSampling RatesInp: * * * * *Out: AESClk : 48kHzDin : XLRThis upper line of this page describes the current format being input to the 300.When no digital signal is present, the display will show "* * * * *" as above.If the incoming audio signal is analog, selecting "Clk" allows Soft knob selectionof the system sample rate for analog operation: 48kHz or 44.1kHz. (Theappropriate sample rate LEDs on the left side of the display will illuminate toindicate the sample rate selected.) If the input is digital, the system willautomatically lock to the sample rate of the incoming data and display "Lock."Otherwise, "***" will be displayed to indicate that the incoming digital signal hasnot yet been detected.Either of the two left buttons on the botton allow selection of AES or SPDIF asoutput format.The two right buttons on the bottom row allow you to specify the connector usedfor audio input: XLR, RCA, or OPT.3-24
Change language