M300 Owner's Manual-English - Lexicon

System OperationSetup Edit mode is used to select the effect to be used in the setup. To enterSetup Edit mode, first go to Setup Select mode and select and load the setupyou want to modify. With the setup selected, press SETUP EDIT.Setup Edit ModeThe specific items available on the various Setup Edit pages are determined bythe type of Setup (Single, Dual Mono or Cascade) which is loaded.Page 1 shows the Effect which is loaded in the currently running Setup andidentifies the setup as SINGLE, DUAL MONO or CASCADE. The Effect IDnumber is underscored, indicating that you can load new Effect Presets orRegisters. To select another Effect, simply turn the softknob to cue up a newEffect, then press ENTER.SIngle SetupsPage OneEA : P209 Podium[SINGLE MACH CONFIG]Page 2 provides adjustment for analog and digital level and source balance intothe unified DSP engine. Simply press the key under the label of the control youwant to adjust and turn the softknob. As you turn the softknob, a long textmessage will be displayed in the display. After a brief timeout, the display willreturn to its orginal state.Page TwoMach A + B Inputs :ALVL ABAL DLVL DBALNote: Press VALUE to display parameter values rather than their labels. Onceyou become familiar with the page layouts in the 300, you may find this modeuseful.Single Setups have only one adjustable parameter on Page 3: OMIX. Thiscontrol adjusts the proportion of “wet” signal to “dry” signal. Most SINGLE SetupPresets have OMIX set to “WET” (100% wet effects).3-13