You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
System OperationThe MIDI Control page allows you to specify mapping of MIDI Non-registeredparameters, System Exclusive messages or Program Change messages to the300 registers. The button directly above "AUTO" allows you to set this MIDIMode.Page TwoMIDI Mode and Map TableMIDI Mode: AUTO CHNLP Chg Map: EDIT DUMPOn the upper line, selecting "AUTO" activates output automation on the 300. Thechoices are OFF, SysEx, Non-registered parameters, and Program ChangeOnly. When the AUTO Mode is set to "OFF", the 300 will not output MIDI data.Note: In "Program Change Only" automation mode, effect registers R29-50 arenot transmitted as their sequence numbers fall outside of the range of what canbe legally represented by a MIDI data byte (0x00-0x7F). Therefore:program change # 0x00-0x63 = E: P1-100program change # 0x64-0x7F = E: R1-28(For more information on Automation, see MIDI Operation.)Selecting "CHNL" allows you to set the system and machine channels on whichthe 300 can send and receive messages. Possible setttings are: 1-16, OMNI. Allbulk dump and SysEx messages, except Program Change, follow the systemchannel, while all generic MIDI and Non-registered parameter messages followthe machine channel assignment.Selecting "EDIT" allows you to speciy the MIDI mapping mode. The threechoices available are: OFF, FIX or MAP. For complete information on the MIDITable, see Chapter 7: MIDI Operation.Selecting "DUMP" allows you to dump all registers, the current setup, the MIDIMap Table, or a MIDI Timecode Event List.3-23
Change language