FELCOM 250 FELCOM 500

3.5.3 SIP settings3. SETTINGS FOR HANDSETThis section describes SIP server settings. Do the procedure if it is necessary to enterSIP settings.1. In the [Settings] menu, press 3 to select [SIP] to show the [SIP] menu.2. Press one of keys 1 -5 depending on your objective.1: Set SIP client.2: Set SIP proxy server.3: Set SIP server port number.4: Set SIP server authentication interval.5: Set RTP port.3. Set SIP by referring to the descriptions in the table.Menu Item DescriptionClient set.*1 Phone number Enter extension number (1000 - 9999).PasswordNicknameEnter SIP password. Up to a maximum of eightalphanumeric characters (upper case alphabetonly) can be used. This password is for identificationat the SIP server.Enter a nickname (maximum of 50 alphabet).The nickname appears on the display of thecalled extension handset.Proxy server *2 IP address Enter the IP address of the SIP proxy server.(IP address for communication unit)S/L port Server port Enter server port number (0 - 65535).Local port Enter local port number (0 - 65535).Expire time - Enter expiration time (1800 - 7200 (sec.)).RTP port RTP port 1 Enter RTP port 1 (1024 - 9998, even numberonly). Set different from RTP port 2.RTP port 2Enter RTP port 2 (1024 - 9998, even numberonly). Set different from RTP port 1.*1: To change both extension number and SIP password at the [Client set.] menu, youmust also change a setting of the Web software at the SIP server. (See page 6-7.) Thetelephone functions cannot be used if the settings for SIP client and SIP server aredifferent.*2: The IP address of the SIP proxy server must be the same as the IP address of thecommunication unit in order to use the telephone function.3-17