VFD-F (CURVE).cdr

VFD-F Series11 - 07 Enter Sleep Process Time Factory Setting: 0.0Settings 0.0~3600.0sec Unit: 0.1 Sec This parameter is to set output frequency of AC drive being smaller than the time intervalbetween sleep frequency and enter sleep process. When AC drive starts running, frequency command calculated by PID is smaller than sleepfrequency. AC drive will enter sleep status and won’t be limited by this parameter. When AC motor drive is in sleep process, SLEEP will be displayed on the digital keypad tillfrequency command attains to wake up frequecy.11 - 08 Sleep Frequency of Sleep Process Factory Setting: 0.00Settings 0.00~11-09 (wake up frequency) Unit: 0.01 This parameter determines frequency after AC drive enters sleep process. After AC drive enters sleep status, it will stop to output signal but PID controller will keepworking.511 - 09 Wake Up Frequency of Sleep Process Factory Setting: 0.00Settings 0.00 to 120.00Hz Unit: 0.01 This parameter determines wake up frequency after AC drive enters sleep process. PID control function will keep calculating frequency command (F) when AC drive is in sleepprocess. When frequency command attains to wake up frequency, AC drive will acceleratefrom 01-05 minimum frequency setting according to V/f curve. The setting of wake up frequency needs to be greater than sleep frequency.FrequencyFrequency command thatcalculates by PID11-0911-0801-0801-05Decelerationtime limitOutput frequencyAccelerationtime limit11-07TimeDELTA ELECTRONICS, INC. ALL RIGHTS RESERVED 5-69