VFD-F (CURVE).cdr

VFD-F Series5.10 Group 9: Communication Parameters09 - 00 Communication Address Factory Setting: 01Settings 01-25400: Disable If the AC drive is controlled by RS-485 serial communication, the communication addressfor this drive must be set via this parameter.09 - 01 Transmission Speed (Baud Rate) Factory Setting: 01Settings 00: Baud rate 480001: Baud rate 960002: Baud rate 1920003: Baud rate 38400 This parameter determines transmission speed of AC drive communication.09 - 02 Transmission Fault Treatment Factory Setting: 03Settings 00: Warn and keep operating01: Warn and RAMP to stop02: Warn and COAST to stop03: No warning and no display This parameter is set to detect if an error occurs and take actions.509 - 03 Time-out Detection during Transmission Factory Setting: 00Settings 00: Disable01: Enable This parameter is used for ASCII mode. When this parameter is set to 01, indicates that theover time detection is enable, the time slot between each character can’t exceed 500 ms.09 - 04 Communication Format Factory Setting: 00Settings00: 7-bit for ASCII01: 8-bit for ASCII02: 8-bit for RTU09 - 05 Even/Odd Parity and Stopping Parity Setting Factory Setting: 00Settings 00: None parity + 2 stop bit01: Even parity + 2 stop bit02: Odd parity + 2 stop bit03: None parity + 1 stop bit04: Even parity + 1 stop bit05: Odd parity + 1 stop bit This parameter determines the communication format of serial communication.DELTA ELECTRONICS, INC. ALL RIGHTS RESERVED 5-45