VFD-F (CURVE).cdr

VFD-F Series08 - 10 Auto Restart Time after Fault Factory Setting: 600Settings 00 to 60000 sec Unit: This parameter determines auto restart time after fault. After fault occurs and restart, thereis no fault occurs during 08-10 setting time, AC drive will reset fault occurred record to zero.08 - 11 Operation Frequency Inhibition 1 UP Factory Setting: 0.0008 - 12 Operation Frequency Inhibition 1 DOWN Factory Setting: 0.0008 - 13 Operation Frequency Inhibition 2 UP Factory Setting: 0.0008 - 14 Operation Frequency Inhibition 2 DOWN Factory Setting: 0.0008 - 15 Operation Frequency Inhibition 3 UP Factory Setting: 0.0008 - 16 Operation Frequency Inhibition 3 DOWN Factory Setting: 0.00Settings 0.00~120.00 Hz Unit: 0.01 This parameter determines the inhibition operation frequency range. This function will letAC drive not run continuous in the resonance frequency of the motor or loading system, orinhibition operation frequency.5 The settings of this parameter should follow as 08-11≧08-12≧08-13≧08-14≧08-15≧08-16. Master frequency command can be set in inhibition operation frequency range. Now theoutput frequency will be limited in the lower bound of inhibition operation frequency. When AC drive accelerates or decelerates, output frequency will pass through inhibitionoperation frequency range.08 - 17 Automatic Energy-saving Factory Setting: 00Settings 00: Energy-saving operation disabled01: Energy-saving operation enabled This parameter determines automatic energy-saving function.Output voltage100%70%During the auto energy-savingoperation, it will adjust the outputvoltage according to the outputpower. The maximum outputvoltage can be 30% lower thanthe normal output voltage.DELTA ELECTRONICS, INC. ALL RIGHTS RESERVED 5-43FrequencyAutomatic Energy-saving Operation