VFD-F (CURVE).cdr

VFD-F SeriesCHAPTER 5 DESCRIPTION OF PARAMETER SETTINGS: This parameter can be set during operation.5.1 Group 0: AC Drive Status Parameters Group 0 is read-only.00 - 00 Software Version Factory setting: Read Only This parameter displays the software version of AC drive.00 - 01 AC Drive Status Indication 1 Factory setting: Read Only This parameter displays the AC drive status.Code AC Drive Status Explanation00 No fault occurred01 oc over current02 ov over voltage03 oH over temperature04 oL overload05 oL1 electronic thermal relay06 EF (external fault) EF-DCM is closed07 occ (AC drive IGBT fault ) IGBT short circuit protection08 cF3 (CPU failure) Abnormal A/D reading during self-check09 HPF (hardware protection failure) Hardware protection function activatedduring self-check.10 ocA (over current during acceleration) Output current exceeds protection levelduring acceleration11 ocd (over current during deceleration) Output current exceeds protection levelduring deceleration12 ocn (over current during steady stateoperation)Output current exceeds protection levelduring steady state operation.13 GFF (ground fault) Ground fault protection feature activated14 Lv (under voltage) Low input voltage15 cF1 EEPROM input data is abnormal16 cF2 EEPROM output data is abnormal17 bb (base block) BB is set and activated18 oL2 (motor over load 2) Output current exceeds rated motor current19 Reserved20 codE software or password protection21 EF1 (external emergency stop) EF1 (a multifunction-DCM is enabled)22 PHL (phase loss) Input power lacks phase.3-phase input power is unbalance andexceeds specification.23 Lc (Low Current) Low current detection during operation.24 FbL(Feedback Loss) Feedback signal is abnormal.25 Reserved5DELTA ELECTRONICS, INC. ALL RIGHTS RESERVED 5-1