VFD-F (CURVE).cdr

VFD-F Series Setting 04: 0-10V = 0.0 - output power factor 1.0 When using 0-20mA output, please refer to Pr. 3-14. Maximum impedance loading of analog output 2 (AFM2) can’t be greater than 500 ohms.03 - 12 Analog Output Gain 1 Factory Setting: 10003 - 13 Analog Output Gain 2 Factory Setting: 100Settings 01~200% This parameter is to determine analog output gain. The analog output is limited to 10V and 20mA. The gain is designed to offer a normallysmall output signal to be enlarged for easier viewing on a meter.03 - 14 Analog Output 2 Selection Factory Setting: 01Settings 00: 0~20mA01: 4~20mA This parameter selects the output range of Analog Output 2 (AFM2).03 - 15 DC Fan Control Factory Setting: 00Settings 00: Fan runs on power up.01: Fan begins upon a RUN command. Fan stops 1 minute after aSTOP command.02: Fan begins upon a RUN command. Fan stops after a STOPcommand03: Fan is controlled by temperature. Approximately a 60°Ctemperature will start the fan. This parameter determines DC fan control method.5-18DELTA ELECTRONICS, INC. ALL RIGHTS RESERVED