VFD-F (CURVE).cdr

VFD-F SeriesOutput voltage01-0201-0401-0601-05 01-08 01-03 01-0101-00 01-07Output Frequency01 - 09 Acceleration Time 1 Factory Setting: 10.0/60.001 - 10 Deceleration Time 1 Factory Setting: 10.0/60.001 - 11 Acceleration Time 2 Factory Setting: 10.0/60.001 - 12 Deceleration Time 2 Factory Setting: 10.0/60.001 - 13 Acceleration Time 3 Factory Setting: 10.0/60.001 - 14 Deceleration Time 3 Factory Setting: 10.0/60.001 - 15 Acceleration Time 4 Factory Setting: 10.0/60.001 - 16 Deceleration Time 4 Factory Setting: 10.0/60.001 - 17 JOG Acceleration Time Factory Setting: 10.0/60.001 - 18 JOG Deceleration Time Factory Setting: 10.0/60.0Settings 0.1~3600.0 Sec Unit: 0.1sec Acceleration time is the time required for the AC drive to ramp from 0 Hz to its MaximumOutput Frequency (Pr.1-00). Deceleration time is the time required for the AC drive todecelerate from Maximum Output Frequency (Pr.1-00) down to 0 Hz. An Acceleration or Deceleration time that is too quick, may cause the AC drives protectionfeatures to enable (over-current stall prevention during Accel 06-01 or over-voltage stallprevention 06-00). If this occurs, the actual Accel/Decel time will be longer than this setting. Warning: An acceleration or deceleration that is too quick, may cause excess loads on theAC drive and may permanently damage the drive. If you want to decelerate the AC drive in short time period, we recommend to add anexternal brake module and brake resistor. You can set 1 st to 4 th Accel/Decel time via multi-function input terminals 04-00 to 04-07.5-6DELTA ELECTRONICS, INC. ALL RIGHTS RESERVED