VFD-F (CURVE).cdr

VFD-F Series5.4 Group 3: Output Function Parameters03 - 00 Multi-function Output terminal 1 Factory Setting: 0003 - 01 Multi-function Output terminal 2 Factory Setting: 0003 - 02 Multi-function Output terminal 3 Factory Setting: 0003 - 03 Multi-function Output terminal 4 Factory Setting: 0003 - 04 Multi-function Output terminal 5 Factory Setting: 0003 - 05 Multi-function Output terminal 6 Factory Setting: 0003 - 06 Multi-function Output terminal 7 Factory Setting: 0003 - 07 Multi-function Output terminal 8 Factory Setting: 00Settings 00-33Setting FunctionsDescriptions00 No function01 Motor No. 102 Motor No. 203 Motor No. 304 Motor No. 4When starting circulative control, AC drive will05 Motor No. 5automatic set this parameter by 11-01 to 11-03.06 Motor No. 607 Motor No. 708 Motor No. 809 Auxiliary 1 output10 Auxiliary 2 outputParameter value 09 to 15 program11 Auxiliary 3 outputMulti-Function Output Terminals12 Auxiliary 4 output(Pr.03-00~Pr.03-07) to correspond with the AC13 Auxiliary 5 outputdrive multi-function input terminals, Pr.04-00 to04-07(settings 20~26).14 Auxiliary 6 output15 Auxiliary 7 output16 Indication during operation The corresponding output will be closed duringoperation (including DC brake time).17 Master frequencyattainedThe corresponding output will be closed whenoutput frequency reaches master frequencycommand.18 Zero Speed (including shutdown) The corresponding output will be closed whenthe AC drive has no output voltage signal.19 Over-torque The corresponding output relay will be closedwhen the AC drives output current exceeds theover-torque detection level 06-04.20 External Fault The corresponding output will be closed whenthe EF is enabled. (Pr. 4-00 to 4-07)5DELTA ELECTRONICS, INC. ALL RIGHTS RESERVED 5-15