Integrator/CP User Guide - ARM Information Center
Integrator/CP User Guide - ARM Information Center
Integrator/CP User Guide - ARM Information Center
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
Connector PinoutsB.2 Peripheral connectorsThis section describes the peripheral connectors located on the baseboard.B.2.1Serial interface connectorsThe pinout of the serial ports is shown in Figure B-3 and Table B-3.1 2 3 4 56 7 8 9Figure B-3 Serial interface connector pinoutTable B-3 Serial interface signal descriptionsPin Signal Type Function1 DCD Input Data carrier detect2 Rx Input Receive3 Tx Output Transmit4 DTR Output Data terminal ready5 GND - Ground6 DSR Input Data set ready7 RTS Output Ready to send8 CTS Input Clear to send9 RI Input Ring indicatorNoteThe serial interfaces signals operate at RS232 signal levels.Serial port functionality corresponds to the DTE configuration.B.2.2Keyboard and mouse connectorsThe pinout of the KMI connectors is shown in Figure B-4 on page B-8.<strong>ARM</strong> DUI 0159B Copyright © 2002 <strong>ARM</strong> Limited. All rights reserved. B-7
Change language