Integrator/CP User Guide - ARM Information Center

PrefaceAbout this documentThis document provides a guide to setting up and using the ARM Integrator/CP.Intended audienceThis document has been written for experienced hardware and software developers asan aid to using the ARM Integrator/CP platform to develop ARM-based products.OrganizationThis document is organized into the following chapters:Chapter 1 IntroductionRead this chapter for an introduction to the ARM Integrator/CP. Thischapter identifies the main components and connectors.Chapter 2 Getting StartedRead this chapter for a description of how to set up and start using theIntegrator/CP. This chapter describes how to attach modules to theIntegrator/CP and how to apply power.Chapter 3 System ArchitectureRead this chapter for a description of the system architecture. Thisincludes the system buses, memory, and programmable devices.Chapter 4 Peripherals and InterfacesRead this chapter for a description of the peripherals supported by theIntegrator/CP.Chapter 5 System ExpansionRead this chapter for a description of the expansion hardware that youcan use with your Integrator/CP.Appendix A Porting Integrator/AP and IM-PD1Refer to this appendix for instructions on porting existing applications toan Integrator/CP system.Appendix B Connector PinoutsRefer to this appendix for a description of the connector signals.Appendix C Test PointsRefer to this appendix for the location of test points.viii Copyright © 2002 ARM Limited. All rights reserved. ARM DUI 0159B