M16C User Manual.pdf

Mitsubishi microcomputersM16C / 62 GroupSINGLE-CHIP 16-BIT CMOS MICROCOMPUTERVersionREV.CContents for changePage 463 Figure 3.2.4 Setting One-shot timer's time3F16 --> 4016.Revisiondate99.12.1Page 465 Figure 3.3.1000016 --> 000116.Page 559 to 562 Figure 7.1.5, Figure 7.1.6, Figure 7.2.1 and Figure 7.2.2All changedPage 560Add to Figure 7.1.7REV.C1Page 567 to 601Add to Appendix.Page 151 Note 2• Before data can be written to the SI/Oi transmit/receive register (addresses036016, 036416), the CLKi pin input must be in the low state. Also, before rewritingthe SI/Oi Control Register (addresses 036216, 036616)’s bit 7 (SOUTi initial valueset bit), make sure the CLKi pin input is held low. ---> • Before data can be writtento the SI/Oi transmit/receive register (addresses 036016, 036416), the CLKi pininput must be in the high state. Also, before rewriting the SI/Oi Control Register(addresses 036216, 036616)’s bit 7 (SOUTi initial value set bit), make sure the CLKipin input is held high.99.12.21REV.C2 00.7.4Page 35, Table 1.12.2_______Normal mode, microprocessor mode, CS0 area0300016 to FFFFF16 --->3000016 to FFFFF16_______Expansion mode 1, microprocessor mode, PM13=1, CS0 area0600016 to FFFFF16 --->0600016 to BFFFF16Page 50, Figure 1.13.6Note: Writing a value to an address after “1” is written to this bit returns the bit to“0” . Other bits do not automatically return to “0” and they must thereforebe reset by the program.Page 150, Figure 1.19.32, bit 5 of the SI/Oi control register (i=3, 4)Transfer direction lect bit --->Transfer direction select bitPage 150, Figure 1.19.32, Note 2When using the port as an input/output port by setting the SI/Oi port select bit (i =3, 4) to “1”, be sure to set the sync clock select bit to “1”.--->When using the port as an input/output port by setting the SI/Oi port select bit (i =3, 4) to “0”, be sure to set the sync clock select bit to “1”.Revision historyM16C/62 User's Manual603