Download - Fuji Xerox Printers

System Settings[System Settings] menu is used to make the printer operation settings such as for alarm andEnergy Saver mode.ItemLow Power TimerDescriptionSets the amount of time before the printer enters the Low Power mode.Specify the value in 1 minute increments.• [2 Minutes] to [60 Minutes] (default: [2 Minutes])Refer to• "2.4 Setting and Exiting Energy Saver" (P. 41)• "Setting Example: Changing the Energy Saver Setting" (P. 85)Sleep ModeConsumes less electricity than the Low Power mode. Set whether or not toenable this feature.• [Enable] (default)• [Disable]Refer to• "2.4 Setting and Exiting Energy Saver" (P. 41)Sleep Mode TimerSets the amount of time before the printer enters the Sleep mode from theLow Power mode. Specify the value in 1 minute increments.• [2 Minutes] to [120 Minutes] (default: [2 Minutes])Note• When [Sleep Mode] is set to [Disable] (default: [Enable]), the printer doesnot shift to the Sleep mode.Refer to• "2.4 Setting and Exiting Energy Saver" (P. 41)Audio TonesSets the audio tones that indicate various printer conditions such as errors.You cannot adjust the sound volume.• [Control Panel] (default: [On])Sets whether or not to generate an audio tone when the correct button ispressed on the control panel.• [Invalid Key] (default: [On])Sets whether or not to generate an audio tone when the wrong button ispressed on the control panel, or when an operation is attempted during anerror.• [Machine Ready] (default: [On])Sets whether or not to generate an audio tone to inform you that the printeris ready to print (such as right after powering on).• [Job Completed] (default: [Off])Sets whether or not to generate an audio tone when a job finishessuccessfully.• [Fault Tone] (default: [On])Sets whether or not to generate an audio tone when a job finishesabnormally.• [Alert Tone] (default: [On])Sets whether or not to generate an audio tone when a fault (such as apaper jam) occurs and a job is held in a fault state.• [Out of Paper] (default: [On])Sets whether or not to generate an audio tone when the printer runs out ofpaper and a job is held in a fault state.• [Low Toner Alert] (default: [On])Sets whether or not to generate an audio tone when a toner cartridge needsto be replaced.• [Base Tone] (default: [On])Sets whether or not to generate an audio tone when a button, which togglesbetween different options when pressed repeatedly, is pressed.5.2 Description of Menu Items 91