GE_OEC_9600_C-Arms

36 System Overview
Keyboard Reassembly
The keyboard should be replaced in the opposite manner to the above disassembly.
When replacing the keyboard assembly, be sure the cables and ground wires are folded
back over the top of the Control Panel Processor PCB and are not pinched.
1. Place the keyboard assembly against the bottom of the monitor bezel and push firmly
to seat the keyboard assembly between the bezel and flat spring attached to the
monitor base plate.
NOTE:
The cutout on the lower rear lip of the keyboard assembly should slip between the
spring and the bezel. The raised ridges along the top rear of the keyboard assembly
should be under the monitor bezel when the assembly is firmly seated.
2. Replace the screws under the front lip of the keyboard assembly (see Figure 19)
and test system operation from the keyboard.