GE_OEC_9600_C-Arms

Mechanical Assemblies 13
C-ARM BEARINGS AND BRAKE
OVERVIEW
The C-arm connects to the Mobile C-Arm via the Flip Flop assembly and the rear
capture bearing design. The C-arm is manually positioned on its radius and the
brake, when engaged, prevents radial C-arm movement.
The rear capture design consists of 8 axial roller bearings and 8 radial roller
bearings. These bearings ensure smooth axial and radial movement of the C-
Arm in relation to the Flip Flop assembly.
C-ARM BRAKE
The cam-levered C-arm brake is contained in the Flip Flop Assembly. Remove
the C-arm as described in the Flip Flop Assembly. Separate the Flip Flop from
the C-arm to inspect the brake.
REAR CAPTURE C-ARM BEARINGS
The axial and radial bearings are contained in the Flip Flop Assembly. Remove
the C-arm as described in the Flip Flop Assembly heading of this section of the
manual. Separate the Flip Flop and C-arm from the L-arm and then separate the
Flip Flop from the C-arm. Inspect nylon rollers for cracks or excessive wear.
Check for smooth bearing operation. Repair or replace bearings and nylon
rollers as required.