GE_OEC_9600_C-Arms

36 Generator Calibration
10R ENTRANCE EXPOSURE CALIBRATION
Use this procedure to change the mA Limit File data within the generator software.
Editing the mA Limit File
1. With the system completely booted, insert the diagnostic disk (00-876781) in the
Workstation. Then press SETUP OPTIONS.
2. Select Access Level 2. Then select Access Mainframe Menu.
3. Select E - mA Limit File Editor. The following menu appears:
_____ mA Limit File Editor _____
MM/DD/YEAR malimit.dat loaded
kVp Maximum mA
40 5.0 A. Fill with constant
41 5.0 B. Clear mA to zero
42 5.0 C. Interpolate Table
43 5.0 D. Set mA high limit
44 5.0 E. Restore Original
45 5.0 F. Edit mA Table
46 5.0
47 5.0 ESC - QUIT
48 5.0
49 5.0
50 5.0 ENTER CHOICE (A,B, . .):
4. Select A. Fill with constant. Enter a value of 5.0.
5. Press ESC. Then press Y to save changes.
6. Select A - Run Applications. Then press ESC twice to clear the right monitor.
7. Verify system compliance as described on the previous page using the "10R
Verification Process" procedure.
8. Copy the MALIMIT.DAT file from the SRAM to the generator backup software
diskette as follows:
• Power on laptop. Select AMICARDZ icon in Windows.
• Remove necessary covers to access Technique Processor PCB
• Remove the SRAM from the Technique Processor PCB.
• Insert SRAM into PCMCIA slot.
• After the message "Card Inserted in Socket 1" appears, select OK.
• Exit to DOS and go to the F:\ drive.
• Insert backup generator diskette in the floppy.