GE_OEC_9600_C-Arms

26 System Overview
COVER REMOVAL
MOBILE C-ARM COVERS
To remove the Mobile C-Arm covers perform the following steps and refer to Figure 12.
WARNING
Electrical circuits inside the equipment use voltages that are capable of
causing serious injury or death from electrical shock.
1. Unplug the system from AC power.
2. Remove the Rear Handle Cover by removing 3 (A) screws located behind the cover
door and one screw (B) on each side at bottom, front of cover.
3. Remove the Front Cover by removing 2 screws (C) near the top of the vertical shaft
under the rubber cover.
4. Remove the Front Leg Cover by removing 8 screws: 2 (D) underneath the toe of the
cover, 2 (E) underneath each cross beam, and 2 (F) from the top front of the cover.
5. Remove the Left Front Cover and Right Front Cover by removing the 3 screws (G)
on each side.
LEFT FRONT COVER
G
C
FRONT COVER
FRONT LEG COVER
F
E
D
A
G
E
REAR COVER HANDLE ASSEMBLY
B
RIGHT FRONT COVER
Figure 12 - C-Arm Cover Removal