GE_OEC_9600_C-Arms

34 Power Distribution
S/N 69-1001 and up
1. Measure at J5-1 on the Battery Charger PCB when performing step 3.
Battery Pack Replacement
WARNING... The batteries are capable of delivering high currents at high voltages and
should be considered fully charged at all times. Remove jewelry such as
rings and watches when working around dangerous voltages.
Refer to Figure 20 for component locations.
1. Verify that the Workstation keyswitch is turned to the OFF position and the AC
power plug is disconnected from the wall receptacle.
2. Remove the Rear Handle Cover Assembly by removing 3 screws located behind
the assembly door and one screw on each side.
3. Remove the Front Cover by removing 2 screws near the top of the vertical shaft.
4. Remove the Right Front Cover by removing the 3 screws securing the cover to the
Mobile C-Arm.
CAUTION! Do not turn CB1 to the OFF position unless the AC power cord has been
unplugged.
5. Turn circuit breaker CB1 to the OFF position.
6. Cut the cable tie that secures the wiring near CB1 and unplug the battery
connectors.
7. Remove the spacer from the top of each battery pack.
8. Lift the battery pack straight up and then pull the pack straight out.
NOTE:
When installing batteries, reconnect battery connectors black to black, red to red, and
blue to blue. Refer to Figure 19. Reset CB1 after the battery connections are made by
moving the switch position to ON.