HP Officejet 4500 (G510) - FTP Directory Listing - Hewlett Packard

More documents

Recommendations

Info

Appendix D There are two communication mode options: • Ad hoc: On an ad hoc network, the device is set to ad hoc communication mode and communicates directly with other wireless devices without the use of a WAP. All devices on the ad hoc network must: ◦ Be 802.11 compatible ◦ Have ad hoc as the communication mode ◦ Have the same network name (SSID) ◦ Be on the same subnet and same channel ◦ Have the same 802.11 security settings • Infrastructure (recommended): On an infrastructure network, the device is set to infrastructure communication mode and communicates with other devices on the network, whether the devices are wired or wireless, through a WAP. WAPs commonly act as routers or gateways on small networks. Security settings NOTE: For more information on wireless security, visit www.weca.net/opensection/pdf/ whitepaper_wi-fi_security4-29-03.pdf. • Network authentication: The device's factory default setting is 'Open,' which does not require security for authorization or encryption. The other possible values are 'OpenThenShared,' 'Shared,' and 'WPA-PSK' (Wi-Fi ® Protected Access Pre-Shared Key). WPA increases the level of over-the-air data protection and access control on existing and future Wi-Fi networks. It addresses all known weaknesses of WEP, the original native security mechanism in the 802.11 standard. WPA2 is the second generation of WPA security; it provides enterprise and consumer Wi-Fi users with a high level of assurance that only authorized users can access their wireless networks. • Data encryption: ◦ Wired Equivalent Privacy (WEP) provides security by encrypting data sent over radio waves from one wireless device to another wireless device. Devices on a WEP-enabled network use WEP keys to encode data. If your network uses WEP, you must know the WEP key(s) it uses. ◦ WPA uses the Temporal Key Integrity Protocol (TKIP) for encryption and employs 802.1X authentication with one of the standard Extensible Authentication Protocol (EAP) types available today. ◦ WPA2 provides a new encryption scheme, the Advanced Encryption Standard (AES). AES is defined in counter cipher-block chaining mode (CCM) and supports the Independent Basic Service Set (IBSS) to enable security between client workstations operating in ad hoc mode. To set up wireless communication using the device control panel with wireless setup wizard The Wireless Setup Wizard provides an easy way to set up and manage a wireless connection to your device. NOTE: To use this method, you must have a wireless network set up and running. 1. Set up the device hardware (see the getting started guide or the setup poster that came with your device). 2. On the device control panel, press the Setup button. 3. Press an arrow button to move to Wireless Menu, and then press OK. 4. Press an arrow button to move to Setup Wizard, and then press OK. 5. Follow the display instructions to complete the setup. 200 Network setup (some models only)
NOTE: If you cannot find the network name (SSID) and WPA key or WEP passphrase, contact your network administrator or the person who set up the wireless network.. To set up wireless communication using the installer (Windows) NOTE: For this method, you will need to have a wireless network set up and running. You will also need a USB cable. Do not attach the USB cable until prompted by the installer. 1. Save any open documents. Close any applications that are running on your computer. 2. Insert the HP software CD into the CD drive. The CD menu runs automatically. If the CD menu does not start automatically, double-click the setup icon on the HP Software CD. 3. On the CD menu, click Install Network/Wireless Device, and then follow the onscreen instructions. NOTE: If the firewall software on your computer displays any messages during the installation, select the “always permit/allow“ option in the messages. Selecting this option allows the software to install successfully on your computer. 4. When prompted, temporarily connect the USB wireless setup cable. 5. Follow the onscreen instructions to complete the installation. NOTE: If you cannot find the network name (SSID) and WPA key or WEP passphrase, contact your network administrator or the person who set up the wireless network. 6. Disconnect the USB wireless setup cable when prompted. To set up wireless communication using the installer (Mac OS X) 1. Connect a USB wireless setup cable to the port on the back of the HP device and then to any USB port on the computer. 2. Place the HP software CD into the computer. 3. Double-click the HP Installer icon on the HP Software CD, and then follow the onscreen instructions. NOTE: If you cannot find the network name (SSID) and WPA key or WEP passphrase, contact your network administrator or the person who set up the wireless network.. 4. Disconnect the USB wireless setup cable when prompted. Connect the device using an ad hoc wireless network connection Method 1 1. Turn on wireless in your computer and in the device. 2. On your computer, connect to the network name (SSID) “hpsetup“. (This network name is the default, ad hoc network created by the HP device.) NOTE: If your HP device was previously configured for a different network, you can restore the network defaults to enable the device to use “hpsetup“. To restore the network defaults complete the following steps: Reset the administrator password and network settings: Select Setup, select Network, and then select Restore Network Defaults. For more information, see General troubleshooting tips and resources. Set up the device for wireless communication (some models only) 201
Page 1:
User Guide OFFICEJET 4500 A909 G510
Page 4 and 5:
Copyright information © 2009 Copyr
Page 6 and 7:
Print photos.......................
Page 8 and 9:
4 Poor print quality and unexpected
Page 10 and 11:
Regulatory information.............
Page 12 and 13:
Use the HP Solution Center (Windows
Page 14 and 15:
Chapter 1 Eco-Tips HP is committed
Page 16 and 17:
Chapter 1 (continued) 4 1-LINE (fax
Page 18 and 19:
Chapter 1 To change settings for a
Page 20 and 21:
Chapter 1 (continued) HP Printing P
Page 22 and 23:
Chapter 1 ◦ Media that is too lig
Page 24 and 25:
Chapter 1 20 Get started To load me
Page 26 and 27:
Chapter 1 Clean the exterior WARNIN
Page 28 and 29:
Chapter 1 4. Lift the automatic doc
Page 30 and 31:
Chapter 2 Print documents (Mac OS X
Page 32 and 33:
Chapter 2 6. In the Basic Options a
Page 34 and 35:
Chapter 2 5. Click Photo Printing -
Page 36 and 37:
Chapter 2 7. Select the paper type:
Page 38 and 39:
Chapter 2 6. Choose Paper Type/Qual
Page 40 and 41:
Chapter 3 3. Press right arrow to s
Page 42 and 43:
Chapter 4 38 Copy • Lighter/Darke
Page 44 and 45:
Chapter 5 TIP: You can also send a
Page 46 and 47:
Chapter 5 Send a fax from memory Yo
Page 48 and 49:
Chapter 5 phone lines. On poor phon
Page 50 and 51:
Chapter 5 NOTE: If Backup fax is en
Page 52 and 53:
Chapter 5 NOTE: If an incorrect pap
Page 54 and 55:
Chapter 5 Receive faxes to your com
Page 56 and 57:
Chapter 5 • Set the fax error cor
Page 58 and 59:
Chapter 5 Set the dial type you are
Page 60 and 61:
Chapter 5 Use reports NOTE: If you
Page 62 and 63:
Chapter 5 Clear the fax log • Num
Page 64 and 65:
6 Work with ink cartridges To ensur
Page 66 and 67:
Chapter 6 Handle the ink cartridges
Page 68 and 69:
Chapter 6 If you are replacing the
Page 70 and 71:
Chapter 6 10. Load the ink cartridg
Page 72 and 73:
Chapter 6 To align the ink cartridg
Page 74 and 75:
7 Solve a problem HP support The in
Page 76 and 77:
Chapter 7 • Messages that appear
Page 78 and 79:
Chapter 7 After the phone support p
Page 80 and 81:
Chapter 7 Check the device software
Page 82 and 83:
Chapter 7 electromagnetic fields. A
Page 84 and 85:
Chapter 7 Step 1: Check the print q
Page 86 and 87:
Chapter 7 Print Quality Diagnostic
Page 88 and 89:
Chapter 7 84 Solve a problem To pre
Page 90 and 91:
Chapter 7 86 Solve a problem The li
Page 92 and 93:
Chapter 7 88 Solve a problem Exampl
Page 94 and 95:
Chapter 7 Solution 9: Replace the p
Page 96 and 97:
Chapter 7 To clean the area around
Page 98 and 99:
Chapter 7 • When using thin speci
Page 100 and 101:
Chapter 7 • Black dots or streaks
Page 102 and 103:
Chapter 7 Part of the document did
Page 104 and 105:
Chapter 7 Take steps to improve the
Page 106 and 107:
Chapter 7 • Make sure you use the
Page 108 and 109:
Chapter 7 port labeled 1-LINE on th
Page 110 and 111:
Chapter 7 • Other equipment, whic
Page 112 and 113:
Chapter 7 • Make sure the device
Page 114 and 115:
Chapter 7 110 Solve a problem • I
Page 116 and 117:
Chapter 7 TIP: If the device came w
Page 118 and 119:
Chapter 7 Solve wireless problems (
Page 120 and 121:
Chapter 7 Mac OS X ▲ Click the Ai
Page 122 and 123:
Chapter 7 3. Do one of the followin
Page 124 and 125:
Chapter 7 Another common problem is
Page 126 and 127:
Chapter 7 Check the device IP addre
Page 128 and 129:
Chapter 7 • If the computer canno
Page 130 and 131:
Chapter 7 Understand the network co
Page 132 and 133:
Chapter 7 2. Gently pull the paper
Page 134 and 135:
A Technical information This sectio
Page 136 and 137:
Appendix A Ink cartridge warranty i
Page 138 and 139:
Appendix A Processor: 192 MHz ARM9
Page 140 and 141:
Appendix A (continued) Media size M
Page 142 and 143:
Appendix A (continued) Tray Type We
Page 144 and 145:
Appendix A (continued) Paper type D
Page 146 and 147:
Appendix A Regulatory information T
Page 148 and 149:
Appendix A Notice to users in Japan
Page 150 and 151:
Appendix A Notice to users of the C
Page 152 and 153:
Appendix A Exposure to radio freque
Page 154 and 155: Appendix A Declaration of conformit
Page 156 and 157: Appendix A Disposal of waste equipm
Page 158 and 159: Appendix A Third-party licenses Thi
Page 160 and 161: Appendix A SHA2 FIPS 180-2 SHA-224/
Page 162 and 163: Appendix A HP Officejet 4500 Third-
Page 164 and 165: Appendix A OpenSSL Copyright (C) 19
Page 166 and 167: Appendix A THIS SOFTWARE IS PROVIDE
Page 170 and 171: Appendix A Expat Copyright (c) 1998
Page 176 and 177: B HP supplies and accessories This
Page 178 and 179: C Additional fax setup After comple
Page 180 and 181: Appendix C • Answering machine: A
Page 182 and 183: Appendix C 3. (Optional) Change the
Page 184 and 185: Appendix C 1 Telephone wall jack 2
Page 186 and 187: Appendix C Back view of the device
Page 188 and 189: Appendix C Set up the device with a
Page 190 and 191: Appendix C 1 Telephone wall jack 2
Page 192 and 193: Appendix C To set up the device wit
Page 194 and 195: Appendix C Shared voice/fax line wi
Page 196 and 197: Appendix C Shared voice/fax line wi
Page 198 and 199: Appendix C Since your computer dial
Page 200 and 201: Appendix C Test fax setup You can t
Page 202 and 203: Appendix D This section contains th
Page 206 and 207: Appendix D To turn off wireless com
Page 208 and 209: Appendix D not simply delete the de
Page 210 and 211: E Device management tools This sect
Page 212 and 213: Appendix E You can open the embedde
Page 214 and 215: Appendix F Ink level warnings and i
Page 216 and 217: Appendix F Solution 2: Turn the pro
Page 218 and 219: Appendix F Usually, you can resolve
Page 220 and 221: default settings copy 38 deleting f
Page 222 and 223: shared with fax and voice line (par
Page 224 and 225: T technical information copy specif
Page 226: 222
show all

HP Officejet 4500 (G510) - FTP Directory Listing - Hewlett Packard

Create successful ePaper yourself

Delete template?

Save as template?