HP Officejet 4500 (G510) - FTP Directory Listing - Hewlett Packard
HP Officejet 4500 (G510) - FTP Directory Listing - Hewlett Packard
HP Officejet 4500 (G510) - FTP Directory Listing - Hewlett Packard
Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
Chapter 7<br />
To clean the area around the ink nozzles<br />
1. Turn on the device and open the ink cartridge door.<br />
The print carriage moves to the far right side of the device.<br />
2. Wait until the print carriage is idle and silent, and then unplug the power cord from<br />
the back of the device.<br />
NOTE: Depending how long the <strong>HP</strong> All-in-One is unplugged, the date and time<br />
might be erased. You might need to reset the date and time later, when you plug<br />
the power cord back in.<br />
3. Lightly press down on the ink cartridge to release it, and then pull it toward you out,<br />
of the slot.<br />
NOTE: Do not remove both ink cartridges at the same time. Remove and clean<br />
each ink cartridge one at a time. Do not leave an ink cartridge outside the device<br />
for more than 30 minutes.<br />
4. Place the ink cartridge on a piece of paper with the ink nozzles facing up.<br />
5. Lightly moisten a clean foam rubber swab with distilled water, and squeeze any<br />
excess water from it.<br />
6. Clean the face and edges around the ink nozzle area with the swab, as shown below.<br />
1 Nozzle plate (do not clean)<br />
2 Face and edges around the ink nozzle area<br />
CAUTION: Do not clean the nozzle plate.<br />
7. Slide the ink cartridge back into the slot. Push the ink cartridge forward until it clicks<br />
into place.<br />
8. Repeat if necessary for the other ink cartridge.<br />
9. Gently close the ink cartridge door and plug the power cord into the back of the device.<br />
Solve paper-feed problems<br />
Media is not supported for the printer or tray<br />
Use only media that is supported for the device and the tray being used. For more<br />
information, see Media specifications.<br />
92 Solve a problem