McKay, Donald. "Front matter" Multimedia Environmental Models ...

More documents

Recommendations

Info

Integrating from an initial condition of C O at zero time gives the following equations: ©2001 CRC Press LLC ln(C/C O) = –kt or C = C O exp(–kt) Rate constants have units of frequency or reciprocal time and are therefore not easily grasped or remembered. A favorite trick question of examiners is to ask a student to convert a rate constant of 24 h –1 into reciprocal days. The correct answer is 576 days –1 , so beware of this conversion! It is more convenient to store and remember half-lives, i.e., the time, t 1/2, which is the time required for C to decrease to half of C O. This can be related to the rate constant as follows. When C = 0.5 C O, then t = t 1/2 ln (0.5) = –kt 1/2, therefore, t 1/2 = 0.693/k For example, an isotope with a half-life of 10 hours has a rate constant, k, of 0.0693 h –1 . 6.3.2 Non-First-Order Kinetics Unfortunately, there are many situations in which the real reaction rate is not a first-order reaction. Second-order rate reactions occur when the reaction rate is dependent on the concentration of two chemicals or reactants. For example, if A + B Æ D + E then the rate of the reaction is dependent on the concentration of both A and B. Therefore, the reaction rate is as follows: N = Vk C A C B Reactant “B” is often another chemical, but it could be another environmental reactant such as a microbial population or solar radiation intensity. Third-order reaction rates, when the rate of reaction is dependent on the concentration of three reactants (N = Vk C A C B C C), are very rare and are unlikely to occur under environmental conditions. We can often circumvent these complex reaction rate equations by expressing them in terms of a pseudo first-order rate reaction. The primary assumption is that the concentration of reactant “B” is effectively constant and will not change appreciably as the reaction proceeds. Thus, the constant k and concentration of reactant “B” can be lumped into a new rate constant, k P, and the second-order reaction becomes a pseudo first-order reaction. Therefore, N = Vk C AC B
and Therefore, ©2001 CRC Press LLC k P = k C B N = Vk P C A which has the form of a simple first-order reaction. Examples of pseudo first-order reactions include photolysis reactions where reactant “B” is the solar radiation intensity (I, in photons/s) or microbial degradations processes where “B” is the populations of microorganisms. Reactions between two chemicals can also be considered a pseudo first-order reaction when C A
Page 1 and 2:
McKay, Donald. "Front matter" Multi
Page 3 and 4:
Multimedia Environmental Models The
Page 5 and 6:
hensive, and reliable, and they hav
Page 7 and 8:
Chapter 1 Introduction Chapter 2 So
Page 9 and 10:
McKay, Donald. "Introduction" Multi
Page 11 and 12:
It is now evident that our task is
Page 13 and 14:
McKay, Donald. "Some Basic Concepts
Page 15 and 16:
give the derived units directly wit
Page 17 and 18:
Energy (joule, J) The joule, which
Page 19 and 20:
particles (aerosols), or biota in w
Page 21 and 22:
Worked Example 2.1 A three-phase sy
Page 23 and 24:
(i) What is the concentration (C) i
Page 25 and 26:
Answer ©2001 CRC Press LLC 5.1 kg,
Page 27 and 28:
or or When t is zero, C is zero, th
Page 29 and 30:
What is the absolute minimum piscic
Page 31 and 32:
©2001 CRC Press LLC C 1 = C O/(1 +
Page 33 and 34:
containing nonequilibrium quantitie
Page 35 and 36:
1. Fallout of chemical from air to
Page 37 and 38:
validated using real environments.
Page 39 and 40:
©2001 CRC Press LLC CHAPTER 3 Envi
Page 41 and 42:
of other, somewhat similar or homol
Page 43 and 44:
Table 3.2 List of Chemicals Commonl
Page 45 and 46:
elatively high concentrations. This
Page 47 and 48:
exists between toxicologists and ch
Page 49 and 50:
determine priority. This is a subje
Page 51 and 52:
Another important classification of
Page 53 and 54:
Figure 3.1 (continued) ©2001 CRC P
Page 55 and 56:
Table 3.5 (continued) dichlorometha
Page 57 and 58:
Table 3.5 (continued) total PCB 326
Page 59 and 60:
Figure 3.2 Plot of log K AW vs. log
Page 61 and 62:
chlorofluoro compounds are very sta
Page 63 and 64:
3.3.2.7 Arsenic Compounds Arsenic,
Page 65 and 66:
McKay, Donald. "The Nature of Envir
Page 67 and 68:
Figure 4.1 Evaluative environments.
Page 69 and 70:
are subject to two important deposi
Page 71 and 72:
metals and organic chemicals from w
Page 73 and 74:
carbon figure for deeper sediments
Page 75 and 76:
flows. The quality of this groundwa
Page 77 and 78:
Table 4.2 Evaluative Environments A
Page 79 and 80:
McKay, Donald. "Phase Equilibrium"
Page 81 and 82:
Figure 5.1 Some principles and conc
Page 83 and 84:
likely using an equilibrium criteri
Page 85 and 86:
Another useful quantity is the rati
Page 87 and 88: experimentally, but not directly, u
Page 89 and 90: ©2001 CRC Press LLC 5.3 PROPERTIES
Page 91 and 92: 1.0. This, then, is the fugacity or
Page 93 and 94: where ©2001 CRC Press LLC pH is -l
Page 95 and 96: In terms of solubilities, S iA and
Page 97 and 98: The temperature coefficient is the
Page 99 and 100: (1982), Baum (1997) and Leo (2000).
Page 101 and 102: Although it may appear environmenta
Page 103 and 104: Figure 5.4 Illustration of quantita
Page 105 and 106: 5.5 ENVIRONMENTAL PARTITION COEFFIC
Page 107 and 108: C S = K PC W benzene = 1.1 ¥ 0.001
Page 109 and 110: Mackay (1986), in an attempt to sim
Page 111 and 112: Compartment Definition of Fugacity
Page 113 and 114: high concentration in the fish, but
Page 115 and 116: heat capacity of 0.38 J/g°C requir
Page 117 and 118: Therefore, ©2001 CRC Press LLC f =
Page 119 and 120: ©2001 CRC Press LLC Z T = S(V i/V
Page 121 and 122: ©2001 CRC Press LLC air Z = P S /R
Page 123 and 124: Table 5.1 Table 5.1 Summary of Defi
Page 125 and 126: Figure 5.7 Fugacity form 1 for dedu
Page 127 and 128: Calculate the following physical-ch
Page 129 and 130: ©2001 CRC Press LLC CHAPTER 6 Adve
Page 131 and 132: that all water will spend 100 days
Page 133 and 134: This enables us to conceive of, and
Page 135 and 136: ©2001 CRC Press LLC f = 15/0.5 = 3
Page 137: D AS dominates. A residence time of
Page 141 and 142: eaction situation in which there is
Page 143 and 144: The rate constants in each case are
Page 145 and 146: ©2001 CRC Press LLC 1/t O = SD Ai/
Page 147 and 148: e achieved in 10 days. Detractors o
Page 149 and 150: sulfate to sulfide or by dechlorina
Page 151 and 152: to Zepp and Cline (1977) for the or
Page 153 and 154: ©2001 CRC Press LLC 6.7 LEVEL II C
Page 155 and 156: Figure 6.3 Fugacity Level II calcul
Page 157 and 158: McKay, Donald. "Intermedia Transpor
Page 159 and 160: Figure 7.1 Illustration of nonequil
Page 161 and 162: 5. Diffusion within soils, and from
Page 163 and 164: sionally, the term flux rate is use
Page 165 and 166: ©2001 CRC Press LLC N = ABDC/ Dy m
Page 167 and 168: no currents or eddies. In practice,
Page 169 and 170: diffusivity, and some unknown layer
Page 171 and 172: where ©2001 CRC Press LLC X = y/ U
Page 173 and 174: fraction of the total volume that i
Page 175 and 176: Figure 7.6 Mass transfer at the int
Page 177 and 178: partition coefficient. The signific
Page 179 and 180: and the series retains a similar ra
Page 181 and 182: ments of resuspension rates are par
Page 183 and 184: Figure 7.8 Movement of air phase (k
Page 185 and 186: ates can thus be used to estimate m
Page 187 and 188: Figure 7.9 Combination of D values
Page 189 and 190:
Figure 7.10 Four-compartment Level
Page 191 and 192:
Table 7.2 Order of Magnitude Values
Page 193 and 194:
Unlike the Level II calculation, it
Page 195 and 196:
Figure 7.12 Sample Level III output
Page 197 and 198:
McKay, Donald. "Applications of Fug
Page 199 and 200:
applications. Citations are given t
Page 201 and 202:
Another approach is to employ Monte
Page 203 and 204:
LEVEL1B A six-compartment Level I p
Page 205 and 206:
Figure 8.1 Air-water exchange proce
Page 207 and 208:
The total rates of transfer are thu
Page 209 and 210:
Figure 8.2 Chemical transport and t
Page 211 and 212:
mean. For chemical between depths o
Page 213 and 214:
8.5.2 Process Description The water
Page 215 and 216:
learn the benefits of using fugacit
Page 217 and 218:
where Figure 8.5 QWASI model: stead
Page 219 and 220:
are similar to those described by M
Page 221 and 222:
C F ª Z Ff W ª 1.608 mol/m 3 ª 4
Page 223 and 224:
y Mackay et al. (1983), and an appl
Page 225 and 226:
accordingly, but the final solution
Page 227 and 228:
Figure 8.10 Fish bioaccumulation pr
Page 229 and 230:
The nature of the processes control
Page 231 and 232:
iomagnification is more significant
Page 233 and 234:
An alternative and more elegant met
Page 235 and 236:
8.11.2 Model of a Chemical Evaporat
Page 237 and 238:
Paterson et al. (1991), and Hung an
Page 239 and 240:
8.14.1 Introduction ©2001 CRC Pres
Page 241 and 242:
mated again in mg/day. Food, the ot
Page 243 and 244:
models. Most interest is in LRT in
Page 245 and 246:
available from the University of To
Page 247 and 248:
McKay, Donald. "Appendix" Multimedi
Page 249 and 250:
©2001 CRC Press LLC
show all

McKay, Donald. "Front matter" Multimedia Environmental Models ...

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?