KR QUANTEC extra - KUKA Robotics

More documents

Recommendations

Info

KR QUANTEC extra Transportation The robot can be transported by fork lift truck or using lifting tackle. Transportation by fork lift truck Transportation with lifting tackle Robot with reach A B C D E F R2500 1576 759 35 58 990 1625 R2700 1740 760 35 39 990 1625 R2900 1740 803 38 87 1143 1754 R3100 1937 798 40 41 1143 1754 Use of unsuitable handling equipment may result in damage to the robot or injury to persons. Only use authorized handling equipment with a sufficient load-bearing capacity. Only transport the robot in the manner specified here. For transport by fork lift truck (>>> Fig. 7-3 ), two fork slots are provided in the base frame. The robot can be picked up by the fork lift truck from the front and rear. The base frame must not be damaged when inserting the forks into the fork slots. The fork lift truck must have a minimum payload capacity of 2.0 t and an adequate fork length. Ceiling-mounted robots can only be transported by fork lift truck. For installation situations in which the fork slots are not accessible, the “Recovery aid” accessory is available. With this device, the robot can also be transported using the fork lift truck. Avoid excessive loading of the fork slots through undue inward or outward movement of hydraulically adjustable forks of the fork lift truck. Fig. 7-3: Transportation by fork lift truck The robot can also be transported using lifting tackle (>>> Fig. 7-4 ). The robot must be in the transport position. The lifting tackle is attached at 3 points to M16 DIN 580 eyebolts. All ropes must be long enough and must be routed in such a way that the robot is not damaged. Installed tools and pieces of equipment can cause undesirable shifts in the center of gravity. The robot may tip during transportation. Risk of personal injury and damage to property. If the robot is being transported using lifting tackle, special care must be exercised to prevent it from tipping. Additional safeguarding measures must be taken. It is forbidden to pick up the robot in any other way using a crane! 110 / 127 Issued: 29.11.2012 Version: Spez KR QUANTEC extra V4 en (PDF)
Fig. 7-4: Transportation using lifting tackle 1 Lifting tackle 3 Rotating column 2 M16 eyebolt 4 Crane Issued: 29.11.2012 Version: Spez KR QUANTEC extra V4 en (PDF) 7 Transportation 111 / 127
Page 1 and 2:
Robots KR QUANTEC extra With F and
Page 3 and 4:
Contents Issued: 29.11.2012 Version
Page 5 and 6:
Issued: 29.11.2012 Version: Spez KR
Page 7 and 8:
1 Introduction 1.1 Industrial robot
Page 9 and 10:
2 Purpose 2.1 Target group 2.2 Inte
Page 11 and 12:
3 Product description 3.1 Overview
Page 13 and 14:
Issued: 29.11.2012 Version: Spez KR
Page 15 and 16:
4 Technical data 4.1 Basic data Bas
Page 17 and 18:
4.2 Axis data Axis data, KR 210 R27
Page 19 and 20:
Fig. 4-1: Working envelope, KR 210
Page 21 and 22:
Page 23 and 24:
Page 25 and 26:
Page 27 and 28:
4.3 Payloads Fig. 4-9: Working enve
Page 29 and 30:
Payloads, KR 90 R2900 extra Load ce
Page 31 and 32:
Fig. 4-11: Payload diagram Issued:
Page 33 and 34:
Fig. 4-13: Payload diagram Issued:
Page 35 and 36:
Mounting flange, adapter (optional)
Page 37 and 38:
4.5 Transport dimensions Issued: 29
Page 39 and 40:
Fig. 4-20: Plates and labels Issued
Page 41 and 42:
Fig. 4-21: Extension 4.7.3 Stopping
Page 43 and 44:
Fig. 4-23: Stopping times for STOP
Page 45 and 46:
Page 47 and 48:
4.7.4.2 Stopping distances and stop
Page 49 and 50:
Page 51 and 52:
Page 53 and 54:
Page 55 and 56:
Page 57 and 58:
Page 59 and 60: 4.7.6.3 Stopping distances and stop
Page 63 and 64: Fig. 4-47: Stopping times for STOP
Page 77 and 78: 4.7.10.2 Stopping distances and sto
Page 87 and 88: 5 Safety 5.1 General 5.1.1 Liabilit
Page 89 and 90: 5.1.4 Terms used Issued: 29.11.2012
Page 91 and 92: Tasks Operator Programmer Switch ro
Page 93 and 94: Issued: 29.11.2012 Version: Spez KR
Page 95 and 96: 5.5 Safety measures 5.5.1 General s
Page 101 and 102: Name Definition Edition EN 614-1 Sa
Page 103 and 104: 6 Planning 6.1 Mounting base with c
Page 105 and 106: 6.2 Machine frame mounting Issued:
Page 107 and 108: Interface for energy supply systems
Page 109: 7 Transportation 7.1 Transporting t
Page 113 and 114: 8 Options 8.1 Mounting flange, adap
Page 115 and 116: 9 KUKA Service 9.1 Requesting suppo
Page 117 and 118: France KUKA Automatisme + Robotique
Page 119 and 120: Poland KUKA Roboter Austria GmbH Sp
Page 121 and 122: Hungary KUKA Robotics Hungaria Kft.
Page 123 and 124: Index Numbers 2004/108/EC 100 2006/
Page 125 and 126: Working range limitation 92 Working
Page 127: Issued: 29.11.2012 Version: Spez KR
show all

KR QUANTEC extra - KUKA Robotics

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?