Modeles 4370 UR1800 Recorder Instruction Manual

IM 4H3B1-01E
9.9 How to Select to Trigger the Recording to Start/Stop
9.9 How to Select to Trigger the Recording to Start/Stop
The start/stop of the recording can be triggered by
• the RCD-key on the keyboard (INTernally triggered), or by
• remote control input (EXTernally triggered).
The initial value is ‘INT’.
Note that if you specify the recording to start/stop in the REMOTE set up (as
‘RECORD’ in 9.7), and you fail to specify EXT here, the recording start/stop will not
be controlled by remote control.
SETTING PROCEDURE:
Enter the SET UP Mode by turning ‘ON’ the power while pressing and holding the
ENT-key until the SET UP display appears.
Use the UP/DOWN-keys to select the display ‘SETUP=RCD’. Press the ENT-key.
The display ‘RECORD=...’ will appear. Select INT or EXT. Press the ENT-key.
This setting has been completed, but has not been stored yet. Before you can adjust
other settings in the SET UP Mode, you have to finish the recording settings until the
‘*RCD SET*’ display appears.
Before leaving the SET UP Mode, you have to store your new settings. Proceed with the
recording settings until the ‘*RCD SET*’ display appears. Press the ESC-key to return
to the ‘SETUP=RCD’ display and then select the ‘SETUP=END’ display.
Press the ENT-key. Select ‘END=STORE’ to keep your new settings or
‘END=ABORT’ and press the ENT-key. After a few seconds, the Operation Mode will
appear.
9 - 23
9. CHANGING INITIAL SETTINGS