Modeles 4370 UR1800 Recorder Instruction Manual
Modeles 4370 UR1800 Recorder Instruction Manual
Modeles 4370 UR1800 Recorder Instruction Manual
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
9.1.5 How to Select the Alarm Indicator to be of HOLD/NON-HOLD Type<br />
You can select whether or not to hold the indicator until reset.<br />
The initial value is ‘NON-HOLD’, and common for all alarms.<br />
NON-HOLD:<br />
Indicator turns ON and OFF together with alarm.<br />
Alarm ON<br />
Alarm OFF<br />
Ind. ON<br />
Ind. OFF<br />
HOLD:<br />
Once flashing, the indicator remains flashing even if the alarm turns OFF. The indicator<br />
shows the current alarm status by pressing the ACK-key (in alarm = ON, alarm<br />
recovered = OFF).<br />
Alarm ON<br />
Alarm OFF<br />
Ind. flash<br />
Ind. ON<br />
Ind. OFF<br />
Press ACK-key<br />
Press ACK-key<br />
SETTING PROCEDURE:<br />
Enter the SET UP Mode by turning ‘ON’ the power while pressing and holding the<br />
ENT-key until the SET UP display appears.<br />
Use the UP/DOWN-keys to select the display ‘SETUP=ALARM’. Press the ENT-key.<br />
Press the ENT-key until the display ‘IND=NONHOLD’ appears. Select HOLD or<br />
NONHOLD. After selection, press the ENT-key.<br />
The indicator HOLD/NONHOLD setting has been completed, but has not been stored<br />
yet. Before you can adjust other settings in the SET UP Mode, you have to finish the<br />
alarm settings until the ‘*ALARM SET*’ display appears.<br />
Before leaving the SET UP Mode, you have to store your new settings. Proceed with the<br />
alarm settings until the display ‘*ALARM SET*’ appears. Press the ESC-key to return<br />
to the ‘SETUP=ALARM’ display and then select the ‘SETUP=END’ display.<br />
Press the ENT-key. Select ‘END=STORE’ to keep your new settings or<br />
‘END=ABORT’ and press the ENT-key. After a few seconds, the Operation Mode will<br />
appear.<br />
9 - 6 IM 4H3B1-01E
Change language