CLI Guide - TP-Link
CLI Guide - TP-Link
CLI Guide - TP-Link
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
TL-SL3428/TL-SL3452 JetStream L2 Managed Switch <strong>CLI</strong> <strong>Guide</strong><br />
Command in the Interface Range Ethernet Mode is executed independently on<br />
all ports in the range. It does not effect the execution on the other ports at all if<br />
the command results in an error on one port.<br />
Example<br />
Enter the Interface Configuration Mode, add ports 1-3, 6-9 to the port-list and<br />
configure them:<br />
<strong>TP</strong>-LINK(config)# interface range ethernet 1-3,6-9<br />
description<br />
Description<br />
The description command is used to add a description to the Ethernet port. To<br />
clear the description of the corresponding port, please use no description<br />
command.<br />
Syntax<br />
description string<br />
no description<br />
Parameter<br />
string —— Content of a port description, ranging from 1 to 16 characters.<br />
Command Mode<br />
Interface Configuration Mode(interface Ethernet)<br />
Example<br />
Add a description Port #5 to port5:<br />
<strong>TP</strong>-LINK(config)# interface ethernet 5<br />
<strong>TP</strong>-LINK(config-if)# description Port #5<br />
shutdown<br />
Description<br />
The shutdown command is used to disable an Ethernet port. To enable this port<br />
again, please use no shutdown command.<br />
Syntax<br />
shutdown<br />
no shutdown<br />
111