CLI Guide - TP-Link

TL-SL3428/TL-SL3452 JetStream L2 Managed Switch CLI Guide
TP-LINK(config)# interface vlan 2
TP-LINK(config-if)#description vlan2
switchport type
Description
Syntax
Parameter
The switchport type command is used to configure the Link Types for the
ports.
switchport type { access | trunk | general }
access | trunk | general —— Link Types. There are three Link Types for the
ports.
Command Mode
Example
Interface Configuration Mode ( interface ethernet / interface range ethernet )
Specify the Link Type of port 5 as general:
TP-LINK(config)# interface ethernet 5
TP-LINK(config-if)#switchport type general
switchport allowed vlan
Description
Syntax
Parameter
The switchport allowed vlan command is used to add the desired port to IEEE
802.1Q VLAN, or to remove a port from the corresponding VLAN.
switchport allowed vlan add vlan-list
switchport allowed vlan remove vlan-list
vlan-list —— VLAN ID list, it is multi-optional.
Command Mode
Example
Interface Configuration Mode ( interface ethernet / interface range ethernet )
Add port 2 to IEEE 802.1Q VLAN:
18