CLI Guide - TP-Link
CLI Guide - TP-Link
CLI Guide - TP-Link
Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
TL-SL3428/TL-SL3452 JetStream L2 Managed Switch <strong>CLI</strong> <strong>Guide</strong><br />
Chapter 8<br />
LACP Commands<br />
LACP (<strong>Link</strong> Aggregation Control Protocol) is defined in IEEE802.3ad and enables the dynamic link<br />
aggregation and disaggregation by exchanging LACP packets with its partner. The switch can<br />
dynamically group similarly configured ports into a single logical link, which will highly extend the<br />
bandwidth and flexibly balance the load.<br />
lacp system-priority<br />
Description<br />
The lacp system-priority command is used to set global lacp system priority.<br />
Syntax<br />
lacp system-priority value<br />
Command Mode<br />
Global Configuration Mode<br />
Parameter<br />
value —— system-priority, ranging from 0 to 65535. By default, the value is<br />
32768.<br />
Example<br />
Set global lacp system priority 1024:<br />
<strong>TP</strong>-LINK(config)# lacp system-priority 1024<br />
lacp (interface)<br />
Description<br />
The lacp(interface) command is used to enable LACP protocol on the current<br />
port. To disable LACP protocol, please use no lacp command.<br />
Syntax<br />
lacp<br />
no lacp<br />
Command Mode<br />
37
Change language