ABB i-Bus® EIB/KNX ABB Powernet EIB/KNX

ABB i-bus ® EIB/KNX
ABB Powernet EIB/KNX
LEANtouch (monochrome),
SMARTtouch (monochrome, colour)
Type: 6x36/30M…, 6x36/100x…, 6x36/100CB…
ceeds or falls below the value of the
other input.
1-byte values can also be sent to the
output object. To do so, the parameter
“Object type of the output” must be set
to “1 byte”. In a similar way to the
switch output, different conditions can
also be set to determine when a telegram
should be sent. The value which
is sent is defined with the settings “It
will be sent if input 1 > input 2” or “…if
input 1 < input 2”. Values between 0
and 255 can be sent.
The output value is sent cyclically if
the setting “Send output cycle” is activated.
The cycle time is set by default
at 9:59 but can be adapted to a required
cycle time.
Status converter
The status converter function records
input values and sends a 14-byte piece
of text to the output object on receipt
of a telegram at the input objects.
Up to four 1-bit input objects can be
created. Output text can be defined for
each logic input state.
Example:
The three 1-bit inputs can in theory
have the following states:
Input 1 Input 2 Input 3
0 0 0
0 0 1
0 1 0
0 1 1
1 0 0
1 0 1
1 1 0
1 1 1
Separate text can be defined for each
input state which is immediately sent
via the 14-byte output communication
object when the state is met.
Alternatively, the input value can also
be set to 1 byte. In this case, the sending
of the text is triggered via the 14-
byte output object on receipt of a
1-byte value at the input object. Up to
16 different input values or output values
can be defined.
82 May 2006