ABB i-Bus® EIB/KNX ABB Powernet EIB/KNX

ABB i-bus ® EIB/KNX
ABB Powernet EIB/KNX
LEANtouch (monochrome),
SMARTtouch (monochrome, colour)
Type: 6x36/30M…, 6x36/100x…, 6x36/100CB…
Parameters: AND, OR, NAND and
NOR logic functions
The default setting for the values
is printed in bold type.
– Used inputs 1 / 2 / 3 / 4
– Type of input 1 Bit / 1 Byte
– Invert inputs No / Yes
– Behaviour of inputs after reset Reading
Given value
Only for 1 bit:
– Given value Off / On
Only for 1 byte:
– Given value 0
– Type of output 1 Bit / 1 Byte
– Behaviour of the output Send always
At change
– After overwriting of output Take value
Do not take value
– Delay of the output No / Yes
telegram
Only if “Yes” is selected:
– Time delay 04:59
Only for 1 bit:
– Output filter Send only on
Send only off
Send on and off
Only for 1 byte:
– Output filter Send only given value
Send only off
Send given value and off
– Given value 1
(1…255)
Parameters: Multiplexer
The default setting for the values
is printed in bold type.
– Object type input/output 1 Bit
1 Byte
2 Byte
Parameters: Multiplier
The default setting for the values
is printed in bold type.
General:
– Starting conditions OFF telegram
ON telegram
– Telegram delay (s) 01:00
Separate for each output:
– Object type Output … 1 Bit / 1 Byte
Only for 1 bit:
– Display output … Off / On
Only for 1 byte:
– Display output … 0
Parameters: Gate function
The default setting for the values
is printed in bold type.
– Control input Activate at OFF
Activate at ON
– Object type of input and output 1 Bit
4 Bit
1 Byte
2 Byte
not assigned
Only for 1 bit:
– During the blocking Do not store input signal
Store input signal
– Filter function Filter nothing
Filter ON
Filter OFF
– Invert output No / Yes
86 May 2006