college information To complete graduation requirements for your ...

80.c
technical/career programs
After UACCM
Graduates are employed as:
• n Field technicians
• n Pumpers
• n Drilling technicians
• n Measurement technicians
• n Compressor operators
• n Completions engineering technicians
• n Drilling fluids engineer
• n Measure-while-drilling engineers
• n Well logging technicians
• n Pressure pumping technicians
• n Land technicians
Related Electives: ................................ 9 credit hours
Nine hours of electives must be selected from the following list:
____ ACR 1303 Schematics ................................. 3 credit hours
____ AST 1203 Engine Repair. .............................. 3 credit hours
____ BUS 2373 Supervisory Management .................... 3 credit hours
____ ELEC 2204 Introduction to Analog and Digital Electronics .. 4 credit hours
____ INT 2003L Internship .................................. 3 credit hours
____ PTRT 2123L Special Projects ............................. 3 credit hours
____ PTRT 2203 Gas Management. ........................... 3 credit hours
____ PTRT 2213 Artificial Lift. ............................... 3 credit hours
____ PTRT 2223 Production Surface Equipment ................ 3 credit hours
____ PTRT 2233 Well Control ................................ 3 credit hours
____ PTRT 2303 Drilling Technology ......................... 3 credit hours
____ TECH 1101 Understanding OSHA Regulations Basics ...... 1 credit hour
____ TECH 1103 Introduction to Hazard Recognition
and Safety Management ................... 3 credit hours
____ WLD 1001L Basic Welding. .............................. 1 credit hour
____ WLD 1202 Craft Skills ................................. 2 credit hours
All technical courses must have been taken within the past five years in order to receive
credit toward any degree in the Department of Technical Studies or in order for the
course to count as a prerequisite for a course. If the course was taken over five years ago,
a student has the option to request prior learning credit by contacting the division chair
for technical studies and following the procedure(s) given.
Petroleum Technology Continued
Petroleum Technology