college information To complete graduation requirements for your ...

85.c
Technical Certificate
38 Semester Hours
* Identifies Arkansas Course Transfer System (ACTS) courses and equivalency numbers
are listed under the Course Descriptions on pages 94-133.
English: ........................................... 3 credit hours
Three hours of English courses must be selected from the following list:
____ ENG 1003 Basic Technical Communications .............. 3 credit hours
____ ENG 1013* Composition I .............................. 3 credit hours
Mathematics:. ..................................... 3 credit hours
Three hours of mathematics courses must be selected from the following list:
____ MATH 1253 Applied Technical Math ...................... 3 credit hours
____ MATH 1113 Quantitative Literacy ........................ 3 credit hours
____ MATH 1203 College Algebra ............................ 3 credit hours
OR MATH (Any Higher-Level Math) .................... 3 credit hours
Technical Core: .................................. 32 credit hours
____ TECH 1202 Soft Skills for Technicians. .................... 2 credit hours
____ TECH 1101 Understanding OSHA Regulations Basic ....... 1 credit hour
____ WLD 1202 Craft Skills ................................. 2 credit hours
____ WLD 1206 Shielded Metal Arc Welding I . . . . . . . . . . . . . . . . . 6 credit hours
____ WLD 2206 Shielded Metal Arc Welding II ................ 6 credit hours
____ WLD 1203 Gas Metal Arc Welding. ...................... 3 credit hours
____ WLD 2103 Blueprint Reading ........................... 3 credit hours
____ WLD 2303 Gas Tungsten Arc Welding ................... 3 credit hours
____ WLD 2306 Pipe Welding ............................... 6 credit hours
The Welding program provides instruction
in Shielded Metal Arc Welding (SMAW),
Gas Metal Arc Welding (GMAW), and
Gas Tungsten Arc Welding (GTAW), as
well as blueprint reading and layout
techniques. Certificates of Proficiency
are offered for SMAW and Pipe Welding.
Students may also complete requirements
for a Technical Certificate in Welding
Technology.
After UACCM
Graduates are employed as:
• n Pipeline construction
• n Metal fabrication
• n Manufacturing firms
• n Industrial companies for equipment repair
Note
n • Students required to take remedial courses
must follow the UACCM Student Success
Plan.
technical/career programs
All technical courses must have been taken within the past five years in order to receive
credit toward any degree in the Department of Technical Studies or in order for the
course to count as a prerequisite for a course. If the course was taken over five years ago,
a student has the option to request prior learning credit by contacting the division chair
for technical studies and following the procedure(s) given.
Welding