Alternative Reader Wiring Guide - Best Access Systems
Alternative Reader Wiring Guide - Best Access Systems
Alternative Reader Wiring Guide - Best Access Systems
Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
<strong>Alternative</strong> <strong>Reader</strong> <strong>Wiring</strong> <strong>Guide</strong><br />
20.7.3 <strong>Reader</strong> Switch Settings<br />
<strong>Reader</strong> configuration SW1 SW2 SW3 SW4<br />
Wiegand 40 bit output off off off ON<br />
20.8. Motorola FlexPass <strong>Reader</strong>s<br />
This reader operates between 4 and 16 VDC. In order to get proper LED functionality, the reader needs to be<br />
wired as follows and set up using 2-wire LED control.<br />
20.8.1 <strong>Wiring</strong> the BAS-1300<br />
TYPICAL SOFTWARE SETTINGS<br />
1. <strong>Reader</strong> Type = WIEGAND/PROX<br />
2. Keypad = NO KEYPAD<br />
3. LED Mode = 2-WIRE LED CONTROL<br />
FlexPass<br />
Motorola<br />
Single <strong>Reader</strong> Interface<br />
GND<br />
BZR<br />
LED<br />
CLK/D1<br />
DATA/D0<br />
VO<br />
Black<br />
Brown<br />
Orange<br />
White<br />
Green<br />
Red<br />
revision 7 — 107