Alternative Reader Wiring Guide - Best Access Systems
Alternative Reader Wiring Guide - Best Access Systems
Alternative Reader Wiring Guide - Best Access Systems
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
<strong>Alternative</strong> <strong>Reader</strong> <strong>Wiring</strong> <strong>Guide</strong><br />
1. AIT <strong>Reader</strong>s<br />
1.1. AIT <strong>Reader</strong> #L-TR200<br />
AIT readers are used for asset tracking. The reader/antenna is connected to a Wiegand data converter and<br />
attached directly to a reader interface module. The Wiegand converter changes the data from RS-485 to a<br />
standard Wiegand data string. This allows the software to function with these readers and cards. The reader<br />
can effectively read the assets up to 45 feet from the reader using asset tags L-TG100 and L-TG200.<br />
1.1.1 <strong>Wiring</strong> the BAS-1300<br />
AIT<br />
Automated Identification Technologies<br />
AIT <strong>Reader</strong><br />
# L-TR200<br />
<strong>Wiring</strong> to Single <strong>Reader</strong> Interface Module<br />
Typical Software Settings<br />
RJ45<br />
Terminating<br />
Connector<br />
<strong>Reader</strong> Type = Wiegand/Prox<br />
Keypad = No Keypad<br />
LED Mode = 2-Wire LED Support<br />
RJ45<br />
Connector<br />
Pin 1<br />
Pin 2<br />
Pin 3<br />
Pin 4<br />
Pin 5<br />
Pin 6<br />
Pin 7<br />
Pin 8<br />
+12<br />
v<br />
GND<br />
Token Return<br />
Tied<br />
Together<br />
Token<br />
In<br />
Rx<br />
+12 v<br />
GND<br />
Red LED<br />
Grn LED<br />
Data 00<br />
Data 01<br />
Pin Outs for RS-485 Connection<br />
Pin 8 = Ground<br />
Pin 7 = Data Tx<br />
Pin 6 = Token In<br />
Pin 5 = +12 v DC<br />
Pin 4 = Token Return<br />
Wiegand Data Converter<br />
GND<br />
BZR (Green LED)<br />
LED (Red LED)<br />
Data 01<br />
Data 00<br />
+12 v<br />
revision 7 — 9