Alternative Reader Wiring Guide - Best Access Systems
Alternative Reader Wiring Guide - Best Access Systems
Alternative Reader Wiring Guide - Best Access Systems
Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
<strong>Alternative</strong> <strong>Reader</strong> <strong>Wiring</strong> <strong>Guide</strong><br />
6. Bewator <strong>Reader</strong>s<br />
6.1. Remote Card <strong>Reader</strong> Model BC18<br />
The reader does not require a separate power supply when being connected to the Dual <strong>Reader</strong> Interface<br />
Module. However, the reader will need an alternate 5 VDC power connection if it is connected to a Single<br />
<strong>Reader</strong> Interface Module. The recommended draw is 40 mA and the reader needs to be connected to 5 VDC.<br />
Also, be sure to set up Jumper J2 for REGULATED power mode. J4 should be configured for 5 VDC.<br />
Recommended operating temperature: -10° to 55° C<br />
6.1.1 <strong>Wiring</strong> the BAS-1300<br />
TYPICAL SOFTWARE SETTINGS<br />
1. <strong>Reader</strong> Type = ALL OTHER READERS<br />
2. Keypad = NO KEYPAD<br />
3. LED Mode = 1-WIRE LED CONTROL<br />
BEWATOR<br />
Single <strong>Reader</strong> Interface Module<br />
GND<br />
BZR<br />
LED<br />
CLK/D1<br />
DATA/D0<br />
VO<br />
Green<br />
Yellow<br />
Grey<br />
BC<br />
18<br />
5 VDC -<br />
Powersupply +<br />
Blue<br />
White<br />
revision 7 — 29
![B.A.S.I.S. G Service Manual [T63300] - Best Access Systems](https://img.yumpu.com/48375082/1/190x245/basis-g-service-manual-t63300-best-access-systems.jpg?quality=85)
Change language