Alternative Reader Wiring Guide - Best Access Systems
Alternative Reader Wiring Guide - Best Access Systems
Alternative Reader Wiring Guide - Best Access Systems
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
<strong>Alternative</strong> <strong>Reader</strong> <strong>Wiring</strong> <strong>Guide</strong><br />
13. HID <strong>Reader</strong>s<br />
Use the following diagrams to wire Single/Dual <strong>Reader</strong> Interface Modules and HID readers.<br />
13.1. HID ProxPro<br />
13.1.1 <strong>Wiring</strong> the BAS-1300<br />
GND<br />
BZR<br />
Single <strong>Reader</strong><br />
Interface Module<br />
LED<br />
CLK/D1<br />
DAT/D0<br />
+12V<br />
TR+<br />
TR-<br />
SG<br />
12 VDC +<br />
Power Supply<br />
(125 mA)<br />
-<br />
TYPICAL SOFTWARE SETTINGS<br />
1. <strong>Reader</strong> Type - Wiegand/Prox<br />
2. HID-09 kepad - eight-bit output keypad<br />
HID-00 keypad - four-bit output keypad<br />
TB1<br />
1 - DC+<br />
2 - GND<br />
3 - Data 0<br />
4 - Data 1<br />
5 - Data RTN<br />
6 - Green LED<br />
7 - Red LED<br />
8 - Beeper<br />
9 - Hold<br />
10 - COM<br />
11 - Tamper<br />
Tamper SW<br />
1<br />
P3<br />
2<br />
3<br />
P1<br />
1 2 3<br />
HID ProxPro<br />
SW1<br />
revision 7 — 57