Alternative Reader Wiring Guide - Best Access Systems
Alternative Reader Wiring Guide - Best Access Systems
Alternative Reader Wiring Guide - Best Access Systems
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
HID <strong>Reader</strong>s<br />
13.9.2 <strong>Wiring</strong> the BAS-1320<br />
TYPICAL SOFTWARE SETTINGS<br />
1. <strong>Reader</strong> Type = WIEGAND/PROX<br />
2. Keypad = EIGHT BIT OUTPUT KEYPAD<br />
3. LED Mode = 1 or 2-WIRE LED CONTROL<br />
Single <strong>Reader</strong><br />
Interface Module<br />
1 2 3<br />
4 5 6<br />
7<br />
*<br />
8<br />
0<br />
9<br />
#<br />
GND<br />
BZR<br />
LED<br />
CLK/D1<br />
DATA/D0<br />
VO<br />
Pin 2 (Ground)<br />
Pin 6 (Red LED)<br />
Pin 5 (Green LED)<br />
Pin 4 (Data 1)<br />
Pin 3 (Data 0)<br />
Pin 1 (+DC (10-16V)<br />
HID<br />
Tie to<br />
Earth<br />
Ground<br />
13.10. EntryProx 4045-905<br />
The EntryProx is a standalone reader. It is ideal for providing single-door proximity access control.<br />
In this configuration, the keypad does not send separate key data. When the keypad is used, it outputs the<br />
cardholder/badge ID number.<br />
72 — revision 7
![B.A.S.I.S. G Service Manual [T63300] - Best Access Systems](https://img.yumpu.com/48375082/1/190x245/basis-g-service-manual-t63300-best-access-systems.jpg?quality=85)
Change language